9362576b, Operating Manual Twin-DVR Sat Receiver ... - Kathrein
9362576b, Operating Manual Twin-DVR Sat Receiver ... - Kathrein
9362576b, Operating Manual Twin-DVR Sat Receiver ... - Kathrein
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Installation Menu<br />
DiSEqC [UFO] Setup<br />
Pay attention to the<br />
bar at the bottom of<br />
the on-screen display!<br />
It provides guidance<br />
on what to do next.<br />
80<br />
22 kHz Signal<br />
You should only make changes in this menu if the receiver is<br />
connected to a different reception system with different properties or if<br />
changes have been made to the reception system.<br />
You should therefore carefully follow the instructions for your <strong>Sat</strong> IF<br />
system. However, before each change you should note the settings<br />
on the form at the end of this operating manual.<br />
Press , and <br />
to access the DiSEqC menu.<br />
This menu option is used to specify whether the 22 kHz signal is to be<br />
used to switch between the upper and lower frequency ranges for a<br />
satellite (low/high) or between two satellite positions.<br />
Tone Burst and DiSEqC Signal<br />
If more than four control criteria are required in a reception system, a<br />
DiSEqC control signal is required.<br />
Which of the setting options - Tone Burst or DiSEqC - is required<br />
depends on the components of the reception system.<br />
You should therefore refer to the descriptions of the existing<br />
components (switching matrices) of the reception system.
Change language