9362576b, Operating Manual Twin-DVR Sat Receiver ... - Kathrein
9362576b, Operating Manual Twin-DVR Sat Receiver ... - Kathrein
9362576b, Operating Manual Twin-DVR Sat Receiver ... - Kathrein
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Installation Menu<br />
Tone Burst<br />
DiSEqC<br />
DiSEqC Repeat<br />
UFO ® mini<br />
Remote Frequency<br />
Here the 22 kHz signal can be set as follows:<br />
Switching states for setting: Switching states for setting: Switching states for setting:<br />
22 kHz Signal —><br />
and<br />
High/Low<br />
Tone Burst —> Pos. A/B:<br />
Low<br />
High<br />
Pos. 1<br />
Pos. 2<br />
22 kHz<br />
22 kHz<br />
Tone Burst<br />
Tone Burst<br />
Off<br />
On<br />
0<br />
1<br />
22 kHz Signal —> Pos. A/B 22 kHz Signal —> Pos. A/B<br />
and<br />
and<br />
Tone Burst —> Opt. A/B<br />
Pos Tone Burst 22 kHz<br />
Tone Burst —><br />
Low Tone Burst<br />
High Tone Burst<br />
High/Low<br />
0<br />
1<br />
1 0 Off<br />
2<br />
3<br />
4<br />
0<br />
1<br />
1<br />
On<br />
Off<br />
On<br />
Pos. 1<br />
Pos. 2<br />
22 kHz<br />
22 kHz<br />
Off<br />
On<br />
If the receiver is connected to a DiSEqC switching matrix, set the<br />
menu option to “On”.<br />
The switching criteria and the input assignment of the DiSEqC<br />
switching matrices must be observed. You should therefore<br />
follow the description of the switching matrices or contact the<br />
engineer who installed the reception system.<br />
If the receiver is operated in a reception system with two or more<br />
DiSEqC switching matrices connected in series (cascaded), the<br />
DiSEqC command must be repeated.<br />
In this case, set the “DiSEqC Repeat” menu option to 1 or 2.<br />
Default setting: “Off”<br />
In a subscriber-controlled processing system, the input frequency of<br />
the receiver is a fixed setting. The subscriber-controlled processing<br />
system transmits the signals at this frequency. The reception<br />
parameters for programme selection are communicated to the<br />
reception system by a DiSEqC command and set.<br />
The setting that has to be selected depends on the design of the<br />
subscriber-controlled processing system.<br />
The setting is made according to the installation instructions for the<br />
subscriber-controlled processing system.<br />
If you have set the UFO®mini menu option to “ON”, use this menu<br />
option to make the setting from the transmission frequency.<br />
The transmission frequency to be set is specified in the installation<br />
manual for the subscriber-controlled processing system.<br />
You should therefore be sure to follow the instructions given in<br />
the installation manual for the subscriber-controlled processing<br />
system.<br />
81
Change language