9362576b, Operating Manual Twin-DVR Sat Receiver ... - Kathrein
9362576b, Operating Manual Twin-DVR Sat Receiver ... - Kathrein
9362576b, Operating Manual Twin-DVR Sat Receiver ... - Kathrein
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Adding/Removing <strong>Sat</strong>ellites<br />
Adding/Removing <strong>Sat</strong>ellites<br />
<strong>Sat</strong>ellite Setup<br />
Pay attention to the<br />
bar at the bottom of<br />
the on-screen display!<br />
It provides guidance<br />
on what to do next.<br />
Note:<br />
In two-cable systems<br />
the tuner input must<br />
be set to "#1 & #2".<br />
The DiSEqC settings<br />
must match the<br />
installed reception<br />
system.<br />
In single-cable<br />
reception select the<br />
tuner input used.<br />
Set Loop when the<br />
output of tuner #1 is<br />
connected to tuner<br />
input #2 or vice versa.<br />
70<br />
New satellites can of course also be added to the LNB configuration.<br />
To do this, you must know the orbit position you need to aim at. The<br />
“Antenna Setup” item on the installation menu can be used as an aid<br />
in aligning the antenna.<br />
To access the “LNB Configuration”, press for the main menu, use<br />
the buttons to select the "Installation“ submenu and confirm with<br />
(also entering your password, if activated). Press to select<br />
“LNB Configuration”, and you can enter or select a new satellite.<br />
Note that your system must be configured accordingly!<br />
In the next step, use the buttons to move to the “User1” entry<br />
for example. After pressing the or button, you are asked if you<br />
want to add the satellite.<br />
Confirm with .<br />
The following message appears: