You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ev 1.5<br />
Reserved of technical modifi cations and/or errors<br />
User’s Manual - <strong>mediaMAX</strong> <strong>MINI</strong><br />
With the spectrum on screen, move the rotary wheel to sweep the frequency band to spot the target<br />
signal. If only spectrum is needed on the monitor, press the buttom “spectrum” to active it.<br />
In cable band, “nav” key selects only frequency mode to sweep the band normally by frequency with<br />
100 KHz steps.<br />
10.3.3 Measurement selection<br />
With the target signal identifi ed, it’s necessary to select the signal type (analog or digital). Press “options”<br />
key, select “Carrier mode” and there will be two differents options:<br />
•<br />
•<br />
Analog: if analog signal<br />
Digital: if digital signal<br />
Select one of them and confi rm clicking the wheel.<br />
For digital cable signal, it is necessary setup signal parameters. Select “Digital modulation”. It is<br />
necessary to setup the following parameters:<br />
1. Symbol rate: This parameter should be fi xed according to the Bit Rate (symbol rate) of<br />
the channel, data which is supplied by the operador.<br />
2. Spectrum inversion: Pushing on this fi eld, you can see the following options:<br />
- Auto: Enables the automatic way of spectrum inversion.<br />
- On: Enables the manual way of spectrum inversion.<br />
- Off: Disables the manual spectrum inversion.<br />
You should enabled in case it is necessary to invert the spectrum. If you select incorrectly<br />
the inversion of the spectrum, the reception will be not correct.<br />
3. Constellation: This parameter will be fi xed according to the modulation of the channel.<br />
This data is supplied by the operator of the channel. You can select different constellations<br />
(modulations): 16-QAM, 32-QAM, 64-QAM, 128-QAM y 256-QAM.<br />
57<br />
ENGLISH