H-1100 - Smiths Medical

More documents

Recommendations

Info

a a Change O-Rings S E C T I O N 1 2 • M a i n t e n a n c e Change the O-Rings in the #1 Block and #2 Block. 1 Remove each O-Ring from its socket by pulling it out with a pair of needle-nose pliers or by prying it out with a small screwdriver. 2 Lubricate the new O-Rings from the O-Ring Kit. 3 Press each O-Ring into its socket. Clean Fan Filter The Fan Filter (a) is located on the bottom of the Fluid Warmer. The fan guard snaps in place. 1 Unsnap and remove the fan guard from the bottom of the unit. 2 Remove the filter and clean it with warm soapy water. 3 When the filter is fairly dry, replace the fan guard and filter. Testing Fluid Warmer Operation Perform all the tests described in the testing section of this manual. See “Testing” on page 32. • Add Recirculating Solution Alarm • Check Disposables Alarm • Over Temperature Alarm • Performance Testing Level 1 ® NORMOFLO ® H-<strong>1100</strong> Irrigation Fluid Warmer | Operator’s Manual 39
Maintenance and Calibration Log All maintenance and testing should be done by qualified personnel authorized by the institution to perform such maintenance. Regularly scheduled maintenance ensures proper functioning of the equipment. Refer to the table below for required tasks and frequency of routine maintenance. Scheduled Maintenance and Calibration Checklist Task Every Use Every 30 Days Every 12 Months Clean the Exterior General Inspection Change Recirculating Solution Lubricate O-Rings Disinfect Recirculating Solution Reservoir Replace O-Rings Clean Fan Filter Perform Over Temperature Alarm Test Test Add Recirculating Solution Alarm Test Disposable Alarm Perform Fluid Warmer Alarm Signal Test Verify Temperature Calibration Electrical Safety Tests 40 Level 1 ® NORMOFLO ® H-<strong>1100</strong> Irrigation Fluid Warmer | Operator’s Manual S E C T I O N 1 2 • M a i n t e n a n c e
Page 1 and 2: Manufacturer: Smiths Medical ASD, I
Page 3 and 4: Level 1 ® NORMOFLO ® H-1100 Irrig
Page 5 and 6: C o n t e n t s 9.3 After Use 29 10
Page 7 and 8: SECTION 2 Description The Level 1
Page 9 and 10: SECTION 4 Important Safety Informat
Page 11 and 12: CAUTIONS Physical injury to the pat
Page 13 and 14: Step 1 - Verify Components of the F
Page 15 and 16: Step 3 - Attach the Fluid Bag Hange
Page 17 and 18: SECTION 6 Principle of Operation Th
Page 19 and 20: SECTION 7 Controls and Displays Thr
Page 21 and 22: Fluid Warmer Display Panel The Flui
Page 23 and 24: SECTION 8 Operation The Level 1 ®
Page 25 and 26: Modes of Operation WARNING • If a
Page 27 and 28: Check Disposables Mode The Check Di
Page 29 and 30: SECTION 9 Operating Instructions Th
Page 31 and 32: A-Install the Irrigation Warming Se
Page 33 and 34: C-Attach Disposable Hand Piece or S
Page 35 and 36: SECTION 10 Troubleshooting Only qua
Page 37 and 38: SECTION 11 Testing This unit should
Page 39 and 40: Performance Testing Cold Start Test
Page 41 and 42: Periodic Electrical Testing Earth L
Page 43: Maintenance Performed Every 12 Mont
Page 47 and 48: C. Conditions of Warranty: The warr
Page 49 and 50: • Service and calibration instruc
Page 51 and 52: Electromagnetic Environmental Recom
Page 53 and 54: Symbols Definitions C D 1 V Latex F
Page 55 and 56: Index A Accessories list 46 Add Rec

H-1100 - Smiths Medical

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?