Vertical mill installation instructions - Haas Automation, Inc.

3. Install and verify operation of the tool changer (see the section on tool changer installation and alignment
for the specific toolchanger). Verify all machine functions.
spindle sweep
Cable
Support
Clamp
Cable
X-Axis Auger
Trough
Cable (To X-Axis
Auger Motor)
X-Axis
Cable
X-Axis Auger Trough
NOTE: The machine must be properly leveled for the spindle sweep adjustment to be
accurate; no more than .0002” twist on the Y-axis (vert mill).
1. To check spindle sweep, place a .0005” indicator on a suitable holder, place on spindle nose and jog the
Z-axis in the negative (-) direction enough so that you can adjust the indicator to sweep a 5" radius from the
center of X- and Y-axis travel. Slowly jog Z-axis in the negative (-) direction to zero out indicator.
2. Establish a reference point (indicator zero), sweep the three remaining points and record the reading.
coolant tank installation
Spindle Sweep Area
10" dia.
circle
1. The coolant pump(s) is packed inside the machine enclosure for shipping.
2. Remove the handle from under the coolant tank lid. Remove the packing material and use the supplied
hardware to attach the handle to the tank.
NOTE: Do not fill the coolant tank before removing the handle from under the lid.
3. Orient the pump(s) and lower into the coolant tank as shown. Place supplied cover as shown. When not
using a TSC pump, install a double lid in place of the single lid (see illustration).
4. Position the coolant tank under the left side of the machine.
32 Installation 96-0284A
© Haas Automation June 2010