IPC@CHIP Documentation - SC12 @CHIP-RTOS V1.10

BATCHMODE=1 :
The listed programs will be executed sequentially, one at time (similar to DOS).
The execution of the successor program will be delayed until the current program either
finishes, terminates resident by calling DOS Interrupt 21h Service 0x31or makes
the @CHIP-RTOS Interrupt 0xA0 Service 0x15batch file wakeup call.
The maximum delay time for execution of the next listed program in the batch file is 15 seconds,
unless this limit has been deactivated with the EXECTIMEOUT=0configurationcontrol.
Important:
If BATCHMODE=1take care that every program in your batch file which has a successor program
either exits (int21h 0x4C)or terminates resident with int21h 0x31.
A program which runs forever should call from the main function @CHIP-RTOS Interrupt
0xA0 Service 0x15, which immediately enables the further batch file sequencing.
Related Topics
Top of list
Index page
BATCH
BATCHMODE command
Run-time batch mode selection API
[BATCH]
EXECTIMEOUT=0/1
Comments
Disable (=0) / enable (=1) the batch file DOS program execution delay time limit for BATCHMODE=1.
EXECTIMEOUT=0 :
The successor program in a batch file waits forever if the predecessor program neither finishes
nor calls 0xA0 Service 0x15.
EXECTIMEOUT=1 : (Default mode)
The maximum delay time for execution of the next listed program in a batch file is 15 seconds.
This Boolean control applies only to BATCHMODE=1.
Example:
[BATCH]
EXECTIMEOUT=0
Related Topics
Top of list
Index page
BATCHMODE Configuration
Page 74 / 400