- Page 1 and 2: EnterpriseServer ES7000Model7600RG2
- Page 3 and 4: Contents Section 1. Safety Safety s
- Page 5 and 6: Section 4. Configuring the server C
- Page 7 and 8: Tables 3-1. I/O-board jumpers . . .
- Page 9 and 10: Section 1 Safety Before installing
- Page 11: DANGER Statement 2: Electrical curr
- Page 15 and 16: DANGER Statement 15: Overloading a
- Page 17 and 18: Section 2 The ES7000 Model 7600R G2
- Page 19 and 20: Documentation Updates This document
- Page 21 and 22: eflections and other nearby noise s
- Page 23 and 24: • Support for ServeRAID-M1015 SAS
- Page 25 and 26: • Call Home Call Home is a Unisys
- Page 27 and 28: • Advanced memory features: - Sin
- Page 29 and 30: Front view The following illustrati
- Page 31 and 32: To access the light path diagnostic
- Page 33 and 34: Serial connector: Connect a 9-pin s
- Page 35 and 36: Turning on the server The power-con
- Page 37 and 38: Before you start the host server to
- Page 39 and 40: Power supply: • One 675-watt (110
- Page 41 and 42: • Hot-swap and redundant power su
- Page 43 and 44: power LED. When the DC power LED is
- Page 45 and 46: Section 3 Installing optional devic
- Page 47 and 48: Orange on a component or an orange
- Page 49 and 50: Backplane 2 (for HDD 4-7) Backplane
- Page 51 and 52: I/O-board connectors Microprocessor
- Page 53 and 54: Jumper number I/O-board LEDs Wake o
- Page 55 and 56: - Boot Failed. Hard Disk 0 - Broadc
- Page 57 and 58: Handling static-sensitive devices A
- Page 59 and 60: DVD signal cable Removing the top c
- Page 61 and 62: 5. Slide the blue latches on the to
- Page 63 and 64:
Removing the bezel Note: You do not
- Page 65 and 66:
Adapter Pin Pin hole Adapter retent
- Page 67 and 68:
5. Push the adapter retention latch
- Page 69 and 70:
If you have other devices to instal
- Page 71 and 72:
Installing a 2.5-inch hard disk dri
- Page 73 and 74:
13. Orient and install the new back
- Page 75 and 76:
19. Install the ServeRAID adapter o
- Page 77 and 78:
7. Remove the backplane filler from
- Page 79 and 80:
4. Pull the lever to slide the driv
- Page 81 and 82:
If you have other devices to instal
- Page 83 and 84:
• Install the DIMMs on each memor
- Page 85 and 86:
Table 3-3. Memory-card installation
- Page 87 and 88:
To install a memory card, complete
- Page 89 and 90:
8. Turn the DIMM so that the DIMM k
- Page 91 and 92:
4. Slide the top cover forward; the
- Page 93 and 94:
Removing the Memory Expansion Modul
- Page 95 and 96:
• The Memory Expansion Module pro
- Page 97 and 98:
Module is attached to a host server
- Page 99 and 100:
Installing optional devices 6. Touc
- Page 101 and 102:
CAUTION: Installing optional device
- Page 103 and 104:
Replacing the Memory Expansion Modu
- Page 105 and 106:
Updating the Memory Expansion Modul
- Page 107 and 108:
Section 4 Configuring the server Th
- Page 109 and 110:
1. Turn on the server. Note: The po
- Page 111 and 112:
Select this choice to view or chang
- Page 113 and 114:
Passwords This choice is on the ful
- Page 115 and 116:
Using the Boot Selection Menu progr
- Page 117 and 118:
available space to allocate from th
- Page 119 and 120:
ES7/7600R G2 Intel PRO/1000 PT Dual
- Page 121 and 122:
You are directed to change CD-ROMs
- Page 123 and 124:
Updating device drivers and PCI car
- Page 125 and 126:
Installation procedure Complete the
- Page 127 and 128:
Note: If you do not remove the medi
- Page 129 and 130:
Preparing to use a Xen Virtual Mach
- Page 131 and 132:
Preinstallation notes • This inst
- Page 133 and 134:
When the initial installation phase
- Page 135 and 136:
If you want to use the server as a
- Page 137 and 138:
3. Click Power Up/Down to start the
- Page 139 and 140:
Installing VMware Patches Updates a
- Page 141 and 142:
To add the USB flash device to the
- Page 143 and 144:
Enabling the Broadcom Gigabit Ether
- Page 145 and 146:
Section 5 Configuring Call Home Cal
- Page 147 and 148:
3. Define the name of your SMTP ser
- Page 149 and 150:
c. Make the following changes: •
- Page 151 and 152:
Appendix A Services and Support Thi
- Page 153 and 154:
Service Task Responsibility Billabl
- Page 155 and 156:
Appendix B Notices Important notes
- Page 157 and 158:
easonable protection against harmfu
- Page 159 and 160:
Japan Electronics and Information T
- Page 161 and 162:
Index A AC power LED, 2-18 adapter
- Page 163 and 164:
DC power, 2-18 error, 3-3 memory, 3
- Page 166:
© Portions copyright Unisys Corpor