ES7000 Model 7600R G2 Installation and User's Guide

The ES7000 Model 7600R G2 Server
• Standby voltage for systems-management features and monitoring
• Startup (boot) from LAN using Preboot Execution Environment (PXE) protocol
• System auto-configuring from the configuration menu
• System error logging
• Upgradeable microcode for POST, IMM, diagnostics, and read-only memory (ROM)
resident code, locally or over the LAN
• Vital product data (VPD) on microprocessors, system boards, power supplies, and SAS
(hot-swap-drive) backplane
• Wake on LAN capability
Obtaining Releases from the Support Site
If you need to install later release levels, such as firmware, you can obtain the desired
versions from the product support Web site, as follows:
1. Access the product support Web site at www.support.unisys.com.
The Product Support log-in page appears.
2. Type your user name and password and click Log In.
The Product Support page appears.
3. Under the ES7000 Servers section, locate 32-bit & 64-bit x86 Architecture and
click ES7000 Model 7600R G2. (Click GO if the selection does not take you to the
next page.)
The ES7000 Model 7600R G2 Support Site page appears.
4. Click Releases in the Options column in the middle of the page.
The ES7000 Model 7600R G2 Releases page appears.
5. Click the item that you want to download.
6. Save the file to the desired location for later use in updating your system.
7. Review any comments about installation of the later version or any read-me files that
are available.
Server controls, LEDs, and power
This section describes the controls, light-emitting diodes (LEDs), connectors on the front
and rear of the server, and how to turn the server on and off.
Note: The illustrations in this document might differ slightly from your server.
2–12 3850 7273–001