ES7000 Model 7600R G2 Installation and User's Guide

The ES7000 Model 7600R G2 Server
Rear view
• Remind button: This button places the system-error LED on the front panel into
Remind mode. In Remind mode, the system-error LED flashes once every 2 seconds
until the problem is corrected, the server is restarted, or a new problem occurs.
By placing the system-error LED indicator in Remind mode, you acknowledge that you
are aware of the last failure but will not take immediate action to correct the problem.
The remind function is controlled by the IMM.
• NMI button: Press this button to force a nonmaskable interrupt to the
microprocessor, if you are directed to do so by service.
• Reset button: Press this button to reset the server and run the power-on self-test
(POST). You might have to use a pen or the end of a straightened paper clip to press
the button. The reset button is in the lower-right corner of the light path diagnostics
panel.
For more information about light path diagnostics, see the Problem Determination and
Service Guide.
The following illustration shows the connectors on the rear of the server.
QPI
ports
1 - 2
Power
connector
Gigabit
Ethernet 1 - 2
System
management
Ethernet
AC
DC
System
serial
!
Video USB
Power-cord connector: Connect the power cord to this connector.
AC
DC
!
QPI
ports
3 - 4
System-management connector: Use this connector to connect the server to a
network for systems-management information control. This connector is used only by the
IMM.
USB connectors: Connect USB devices, such as a USB mouse or keyboard, to these
connectors.
Video connector: Connect a monitor to this connector. In a two-node configuration,
connect the monitor to the primary server to see standard system output.
2–16 3850 7273–001