Create OMR Job - Pitney Bowes Canada

Operation
If you have material loaded,
press Trial Piece. The
machine will set itself and
run a test piece for you to
check.
If you don’t have material loaded, do this now, then return to
this section. Loading feeders etc. is covered on the following
pages.
Note:
You may have selected a
‘manual feed’ job where
sheet feeder 1 is set for
manual feed of collated sets.
If this is the case, the sheet
feeder should not be loaded,
as the collated sets are fed
one at a time as required by
the machine. However, the
lever shown in the illustration should be pulled back to open
the feed mechanism to ready the manual feed operation.
Remember to return this lever to its normal position when
you use the feeder for automatic operation.
Run a Trial Piece
Once material is in place, press Trial Piece so you can
check that the setup is correct.
Note: In switchable mode both sheet feeders must be loaded. A
trial piece will be run for both feeders.
Minor changes to the job settings can be made at this stage
if the trial piece needs ‘fine tuning’. Press Setup, then use
the Prev ( ), Next ( ) and Change (+/-) buttons as
required to modify job settings. When you have made the
necessary changes, press Setup again to return to run
mode. The job will be saved with the new settings.
2-2