Create OMR Job - Pitney Bowes Canada

Create Non-OMR Job
When this is complete, the
display will show the new job
with the message ‘Trial Piece
Required’.
Job settings will be retained by the machine even with power
disconnected until they are changed or deleted as described
on the following page.
Testing the Job
Load material and press Trial Piece so that you can check
that the setup is correct.
Minor changes to the job settings can be made at this stage
if the trial piece needs ‘fine tuning’. Press Setup, then use
the Prev ( ), Next ( ) and Change (+/-) buttons as
required to modify job settings. A chart is provided below to
help ‘fine tune’ your fold settings.
FOLD TYPE ADDRESS TOO LOW ADDRESS TOO HIGH
“C” - Letter Fold Decrease Fold A Increase Fold A and
increase Fold B by the
same amount
“Z” - Accordion Increase Fold A Decrease Fold A and
Fold increase Fold B
by the same amount
Single Fold Increase Fold A Decrease Fold A
Double Fold Decrease Fold A Increase Fold A
It is recommended that the folds are changed by 5mm each
time and a new trial piece run to test the settings. When you
have made the necessary changes, press Setup again to
return to run mode. The job will be saved with the new
settings.
3-14