Owner's Manual - Infiniti Owner Portal - Infiniti USA

that lacks safety stop and reverse
features as required by federal safety
standards. (These standards became
effective for opener models manufactured
after April 1, 1982). A garage door
opener which cannot detect an object in
the path of a closing garage door and
then automatically stop and reverse,
does not meet current federal safety
standards. Using a garage door opener
without these features increases the risk
of serious injury or death.
. During the programming procedure your
garage door or security gate will open
and close (if the transmitter is within
range). Make sure that people or objects
are clear of the garage door, gate, etc.
that you are programming.
. Your vehicle’s engine should be turned
off while programming the HomeLink ®
Universal Transceiver. Do not breathe
exhaust gases; they contain colorless
and odorless carbon monoxide. Carbon
monoxide is dangerous. It can cause
unconsciousness or death.
2-62 Instruments and controls
PROGRAMMING HomeLink ®
If you have any questions or are having
difficulty programming your HomeLink ®
buttons, refer to the HomeLink ® web site
at: www.homelink.com or call 1-800-355-
3515.
NOTE:
It is also recommended that a new battery
be placed in the hand-held transmitter of
the device being programmed to
HomeLink ® for quicker programming and
accurate transmission of the radio-frequency.
1. Position the end of your hand-held
transmitter 1-3 in (26-76 mm) away
from the HomeLink ® surface, keeping
the HomeLink ® indicator light *1 in
view.
JVI0428X
2. Using both hands, simultaneously
press and hold the desired HomeLink ®
button and handheld transmitter button.
DO NOT release until the
HomeLink ®
indicator light *1 flashes
slowly and then rapidly. When the
indicator light flashes rapidly, both
buttons may be released. (The rapid
flashing indicates successful programming.)
NOTE:
Some devices to be programmed may
require you to replace Step 2 with the
cycling procedure noted in the “Programming
HomeLink ® for Canadian