Owner's Manual - Infiniti Owner Portal - Infiniti USA

INSTALLING FRONT LICENSE PLATE
9-14 Technical and consumer information
STI0722
Use the following steps to mount the
license plate:
Before mounting the license plate, confirm
that the following parts are enclosed in the
plastic bag.
Only use the recommended mounting
position, otherwise the Intelligent Cruise
Control (ICC) sensor obstruction (if so
equipped) may result.
. License plate bracket
. J-nut 6 2
. Screw 6 2
. Screw grommet 6 2
1. Park the vehicle on flat, level ground.
2. Locate the center position *A as
illustrated. Line up the license plate
bracket under the top of the front
bumper *B with the tabs *C . Hold
the license plate bracket in place.
3. Mark the center of the hole *D with a
felt-tip pen.
4. Carefully drill two pilot holes using a
0.39 in (10 mm) drill bit at the marked
locations. (Be sure that the drill only
goes through the bumper fascia.)
5. Insert grommets into the hole on the
fascia.