Owner's Manual - Infiniti Owner Portal - Infiniti USA

AUTOMATIC CLIMATE CONTROL
(Type B)
Automatic operation
Cooling and/or dehumidified heating
(AUTO):
This mode may be used year-round as the
system automatically controls constant
temperature, air flow distribution and fan
speed after the desired temperature is set
manually.
1. Push the “AUTO” button.
(The AUTO indicator light on the button
will illuminate and “AUTO” will appear
on the display.)
2. Push the temperature control button
(driver’s side) to set the desired temperature.
. The temperature can be set within
the following range.
— For U.S.: 60 to 908F (16 to 328C)
— For Canada: 64 to 908F (18 to
328C)
. The temperature of the passenger
compartment will be maintained
automatically. Air flow distribution
and fan speed will also be controlled
automatically.
3. To turn off the climate control system,
push the “OFF” button.
A visible mist may be seen coming from the
ventilators in hot, humid conditions as the
air is cooled rapidly. This does not indicate
a malfunction.
Dehumidified defrosting/defogging:
1. Push the “ ” button. (The indicator
light will illuminate.)
2. Push the temperature control button
(driver side) to set the desired temperature.
. To remove frost from the outside
surface of the windshield quickly,
set the temperature control and fan
speed control to their maximum
position.
. After the windshield is cleared, push
the “AUTO” button to set to the
automatic mode.
. When the “ ” button is pushed,
the air conditioner will automatically
turn on when the outside air temperature
is above 238F (−58C) to
defog the windshield. The air recirculation
mode will automatically
turn off. The outside air circulation
mode will be selected to improve the
defogging performance.
Manual operation
The manual mode can be used to control
the heater and air conditioner to your
desired settings.
To turn off the heater and air conditioner,
push the “OFF” button.
Fan speed control:
Push the fan speed control “ ” button
to increase the fan speed.
Push the fan speed control “ ” button to
decrease the fan speed.
Push the “AUTO” button to change the fan
speed to the automatic mode.
Air flow control:
Push the “ ” button to change the air
flow mode.
: Air flows from the center and side ventilators.
: Air flows from the center and side ventilators,
and foot outlets.
: Air flows mainly from the foot outlets.
: Air flows from the defroster and foot outlets.
Temperature control:
Turn the temperature control dial to set the
desired temperature.
Monitor, climate, audio, phone and voice recognition systems 4-41