Runtime for ClearPath MCP Installation and Configuration Guide
Runtime for ClearPath MCP Installation and Configuration Guide
Runtime for ClearPath MCP Installation and Configuration Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Pre-<strong>Installation</strong><br />
Use of the ERASE INPUT <strong>and</strong> ERASE EOF keys will cause the deletion of prefilled blanks<br />
in the data item field where the cursor is positioned. This will cause data item length<br />
errors when transmitted.<br />
<strong>Configuration</strong> In<strong>for</strong>mation<br />
IBM 3270 terminals <strong>and</strong> controllers must support <strong>and</strong> be configured <strong>for</strong> 1920-character<br />
displays. Line configuration should be set <strong>for</strong> BISYNC line protocol.<br />
IBM 3270 terminals must be defined in the Network as type IBM3270 devices as the<br />
terminal type cannot be determined dynamically.<br />
SOURCE NDL II IBM 3270 BISYNC algorithm <strong>and</strong> editor are required. The COMS UTILITY<br />
Station definition <strong>for</strong> 3270 devices must have a TRANCODE position value of 7.<br />
Library Operation Description<br />
The library system /1/3270 is automatically generated <strong>for</strong> each system, <strong>and</strong> is called when<br />
needed <strong>for</strong> both input <strong>and</strong> output messages <strong>for</strong> an IBM 3270-type terminal.<br />
On input, all cursor <strong>and</strong> field address in<strong>for</strong>mation is stripped off <strong>and</strong> the length adjusted. If<br />
a PF or PA key is used, a keyed response is generated. On output, a Unisys terminal<br />
output response is converted to the equivalent response <strong>for</strong> an IBM 3270-type terminal.<br />
2–16 78616208–001
Change language