Design and Specification Guidelines - Gaston County Schools
Design and Specification Guidelines - Gaston County Schools
Design and Specification Guidelines - Gaston County Schools
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Design</strong> <strong>and</strong> <strong>Specification</strong> <strong>Guidelines</strong> <strong>Gaston</strong> <strong>County</strong> <strong>Schools</strong><br />
Updated: March 6, 2012 <strong>Gaston</strong>ia, NC 28054<br />
2. Materials<br />
a) General: Provide materials that comply with requirements of the AWI<br />
quality st<strong>and</strong>ard for each type of woodwork <strong>and</strong> quality grade specified,<br />
unless otherwise indicated.<br />
b) Particleboard: ANSI A208.1 1999 Industrial Grade M2<br />
c) Countertops:<br />
(1) At sink: 1-inch moisture resistant particleboard. ANSI A208.1<br />
1999 Grade M3<br />
(2) Other locations: 1-inch particleboard. ANSI A208.1 1999 Grade<br />
M2<br />
d) Plastic Laminate: High Pressure Decorative Laminate: NEMA LD 3<br />
(1) Install at all visible exterior surfaces including bottom of wall<br />
cabinets.<br />
(2) Install on all interior surfaces of open cabinetry.<br />
(3) Thermoset Decorative Overlay: Over Particleboard for Semiexposed<br />
Surfaces Interior finish of cabinets to be thermally fused<br />
melamine impregnated decorative paper complying with LMA SAT-<br />
1<br />
e) Edging: PVC b<strong>and</strong>ing<br />
(1) 3 mm at drawer, shelves <strong>and</strong> door edges, front edges of<br />
cabinetry.<br />
f) Adjustable Shelving<br />
(1) 3/4-inch thick for up to 36-inch length.<br />
(2) 1-inch thick for over 36-inch length<br />
(3) 3 mm edging at all shelf edges so shelves can be flipped <strong>and</strong><br />
reversed.<br />
3. Hardware <strong>and</strong> Accessories<br />
a) 5 knuckle hinges: satin stainless steel finish<br />
b) Wire Pulls: 4 inches long.<br />
c) Magnetic catches.<br />
d) Drawer slides:<br />
(1) side mounted, full extension, ball bearing<br />
(2) 100 lb capacity at box drawers<br />
(3) 200 lb capacity at file drawers<br />
(4) 45 lb capacity at pencil drawers<br />
e) Shelf Supports: Adjustable, polycarbonate, anti-tilt, twin pin locking shelf<br />
clip that accepts both 3/4 inch <strong>and</strong> 1 inch thick shelves.<br />
*=Preferred Br<strong>and</strong>; Bid Alternate Required Page 17 of 38 Pages