3 - Wacker Neuson Group

More documents

Recommendations

Info

3 PT SERIES PUMPS PT / PG / PD REPAIR 3.19 Frame Assembly (PT2 Shown) 3-24 10 9 8 5 4 7 2 1 6 5 3 1004SD40
PT / PG / PD REPAIR PT SERIES PUMPS 3 3.19 Frame Assembly (cont.) Recommended tools: Socket wrench - 1/2" (13mm), 11/16" (17mm), 3/4" (19mm) Allen wrench - 6mm Removal: 1. Remove hardware (1) mounting console (2) to shockmounts (3). Remove from frame. Note: Mounting hardware varies on all PT Series Pumps. 2. Remove four screws (4), washers (5), and four locknuts (6) mounting engine side (7) to console. 3. Remove two screws (8) and washers (9) mounting pump side (10) to console. Installation: 1. Mount pump side (10) to console (2) using screws (8) and washers (9). Apply Loctite 243 or an equivalent medium strength threadlocker and torque to 28 ft.lbs (38 Nm). 2. Mount engine side (7) to console (2) using screws (4), washers (5), and locknuts (6). Torque to 29 ft.lbs (40 Nm). 3. Mount console (2) to shockmounts (3) using hardware (1). Note: See sealant and torque reference charts in back of book for appropriate threadlocking adhesives and torque values. WARNING Before you start the machine, ensure that all tools have been removed from the machine and that replacement parts and adjusters are firmly tightened. 3-25
Page 1:
www.wackergroup.com REPAIR MANUAL 0
Page 4 and 5:
FOREWORD PT / PG / PD REPAIR Namepl
Page 6 and 7:
FOREWORD PT / PG / PD REPAIR Item N
Page 8 and 9:
1 GENERAL PT / PG / PD REPAIR 1.1 S
Page 10 and 11: 1 GENERAL PT / PG / PD REPAIR 1.7 O
Page 12 and 13: 1 GENERAL PT / PG / PD REPAIR 1.10
Page 26 and 27: 2 OPERATION PT / PG / PD REPAIR 2.1
Page 38 and 39: 3 PT SERIES PUMPS PT / PG / PD REPA
Page 72 and 73: 4 PG SERIES PUMPS PT / PG / PD REPA
Page 90 and 91: 5 PD SERIES PUMPS PT / PG / PD REPA
Page 110 and 111:
5 PD SERIES PUMPS PT / PG / PD REPA
Page 112:
TORQUE VALUES Metric Fasteners (DIN
show all

3 - Wacker Neuson Group

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?