technical manual operator instructions

More documents

Recommendations

Info

Table 2-1. PREVENTIVE MAINTENANCE CHECKS AND SERVICES FOR MASK, CHEMICAL-BIOLOGICAL: M45 (con’t) ITEM NO. INTERVAL LOCATION PROCEDURE NOT FULLY MISSION CAPABLE IF: ITEM TO CHECK/ SERVICE 6 Before Inlet Valve Assembly a. Fold back left side of nosecup to fully expose inlet valve assembly. Check that inlet valve disk (1) is present and positioned in the slot on the cage and post assembly (2). Check cage for cracks. Inlet valve disk is missing or not positioned on the cage and post assembly. Cage is cracked, missing or not positioned on port gasket. b. Check inlet valve disk (1) for tears and curls. Make sure inlet valve disk lies flat. Inlet valve disk has tears, curls, or does not seat against inlet valve gasket. 2-9
Table 2-1. PREVENTIVE MAINTENANCE CHECKS AND SERVICES FOR MASK, CHEMICAL-BIOLOGICAL: M45 (con’t) ITEM NO. 6 con' t INTERVAL LOCATION PROCEDURE NOT FULLY MISSION CAPABLE IF: ITEM TO CHECK/ SERVICE Before Inlet Valve Assembly c. Rotate inlet valve disk (1) and cage and post assembly (2) with finger. Make sure it lies flat and does not stick. Inlet valve disk sticks. 2-10
Page 1 and 2: TM 3-4240-341-10 TECHNICAL MANUAL O
Page 3 and 4: WARNING SUMMARY This publication de
Page 5 and 6: WARNING SUMMARY (CONT) o You must c
Page 7 and 8: EXPLANATION OF SINGLE HAZARD SYMBOL
Page 9 and 10: HEALTH/ENVIRONMENTAL HAZARD Filter
Page 11 and 12: TABLE OF CONTENTS (CONT) APPENDIX A
Page 13 and 14: Fig 1. Mask, Chemical-Biological: M
Page 15 and 16: SECTION I. GENERAL INFORMATION (CON
Page 17 and 18: SECTION I. GENERAL INFORMATION (CON
Page 19 and 20: SECTION II. EQUIPMENT DESCRIPTION A
Page 27 and 28: SECTION III. THEORY OF OPERATION (C
Page 29 and 30: SECTION III. THEORY OF OPERATION (C
Page 31 and 32: 2.1.1 General (CONT). a. Perform PM
Page 33 and 34: 2.1.2 PMCS Procedures (CONT). f. Th
Page 35 and 36: Table 2-1. PREVENTIVE MAINTENANCE C
Page 37: Table 2-1. PREVENTIVE MAINTENANCE C
Page 67 and 68: 2.2 MANDATORY REPLACEMENT PARTS. Th
Page 69 and 70: 2.4 DONNING YOUR MASK (CONT). c. Pu
Page 71 and 72: 2.4 DONNING YOUR MASK (CONT). f. Bl
Page 73 and 74: 2.5 FIT CRITERIA. a. Verify the fit
Page 75 and 76: 2.6 PUTTING YOUR MASK ON IN COLD WE
Page 77 and 78: 2.7.1 CONNECTING THE DRINKING SYSTE
Page 79 and 80: 2.7.1 CONNECTING THE DRINKING SYSTE
Page 81 and 82: 2.8 REMOVING YOUR MASK. a. Disconne
Page 83 and 84: 2.9 STOWING YOUR MASK AND ADDITIONA
Page 85 and 86: 2.9 STOWING YOUR MASK AND ADDITIONA
Page 87 and 88: 2.10 WEARING YOUR MASK CARRIER (CON
Page 89 and 90:
2.12 INSTALLATION OF HOOD. a. Remov
Page 91 and 92:
2.13 WEAR AND LOCATION OF THE CANIS
Page 93 and 94:
No lubrication is required for the
Page 95 and 96:
3.2 CHECKING YOUR MASK FOR LEAKS (C
Page 97 and 98:
3.4 CLEANING (CONT). c. Soak brush
Page 99 and 100:
3.4 CLEANING (CONT). m. Clean outsi
Page 101 and 102:
APPENDIX A REFERENCES A-1. SCOPE. T
Page 103 and 104:
APPENDIX B COMPONENTS OF END ITEM A
Page 105 and 106:
B-3. EXPLANATIONS OF COLUMNS (CONT)
Page 107 and 108:
APPENDIX C ADDITIONAL AUTHORIZATION
Page 109 and 110:
SECTION II. ADDITIONAL AUTHORIZATIO
Page 111 and 112:
D-2. EXPLANATION OF COLUMNS (CONT).
Page 114:
DID WE GOOF? DO YOU KNOW A BETTER W
show all

technical manual operator instructions

Create successful ePaper yourself

Delete template?

Save as template?