technical manual operator instructions

More documents

Recommendations

Info

3.4 CLEANING (CONT). CAUTION Abrasive material in carrier will scratch outserts and eyelenses. Do not soak carrier; do not use hot water, bleach, or detergent to clean it. These will reduce water resistance of carrier. Ensure mask and all components are entirely dry before stowing or reassembly. Do not put mask or components in pail of water. When you clean your mask, use only potable water. See unit maintenance for supplies or assistance, if needed. a. Remove contents from carrier. b. Shake carrier upside down to remove dirt and foreign matter. 3-4
3.4 CLEANING (CONT). c. Soak brush (item 2, app D) in cool water. d. Shake brush to remove excess water. e. Clean carrier with brush. f. Remove hood and outserts. g. Remove drink tube (1) out of drink tube holder. h. Grasp tab (2) and stretch outlet valve cover (3) over barb (4) and lift outlet valve cover from outlet valve housing (5). i. Clean your mask, hood, outserts, second skin and inserts using cheesecloth (item 3, app D), soap (item 6, app D), 3-5
Page 1 and 2:
TM 3-4240-341-10 TECHNICAL MANUAL O
Page 3 and 4:
WARNING SUMMARY This publication de
Page 5 and 6:
WARNING SUMMARY (CONT) o You must c
Page 7 and 8:
EXPLANATION OF SINGLE HAZARD SYMBOL
Page 9 and 10:
HEALTH/ENVIRONMENTAL HAZARD Filter
Page 11 and 12:
TABLE OF CONTENTS (CONT) APPENDIX A
Page 13 and 14:
Fig 1. Mask, Chemical-Biological: M
Page 15 and 16:
SECTION I. GENERAL INFORMATION (CON
Page 17 and 18:
SECTION I. GENERAL INFORMATION (CON
Page 19 and 20:
SECTION II. EQUIPMENT DESCRIPTION A
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
SECTION III. THEORY OF OPERATION (C
Page 29 and 30:
SECTION III. THEORY OF OPERATION (C
Page 31 and 32:
2.1.1 General (CONT). a. Perform PM
Page 33 and 34:
2.1.2 PMCS Procedures (CONT). f. Th
Page 35 and 36:
Table 2-1. PREVENTIVE MAINTENANCE C
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46: Table 2-1. PREVENTIVE MAINTENANCE C
Page 67 and 68: 2.2 MANDATORY REPLACEMENT PARTS. Th
Page 69 and 70: 2.4 DONNING YOUR MASK (CONT). c. Pu
Page 71 and 72: 2.4 DONNING YOUR MASK (CONT). f. Bl
Page 73 and 74: 2.5 FIT CRITERIA. a. Verify the fit
Page 75 and 76: 2.6 PUTTING YOUR MASK ON IN COLD WE
Page 77 and 78: 2.7.1 CONNECTING THE DRINKING SYSTE
Page 79 and 80: 2.7.1 CONNECTING THE DRINKING SYSTE
Page 81 and 82: 2.8 REMOVING YOUR MASK. a. Disconne
Page 83 and 84: 2.9 STOWING YOUR MASK AND ADDITIONA
Page 85 and 86: 2.9 STOWING YOUR MASK AND ADDITIONA
Page 87 and 88: 2.10 WEARING YOUR MASK CARRIER (CON
Page 89 and 90: 2.12 INSTALLATION OF HOOD. a. Remov
Page 91 and 92: 2.13 WEAR AND LOCATION OF THE CANIS
Page 93 and 94: No lubrication is required for the
Page 95: 3.2 CHECKING YOUR MASK FOR LEAKS (C
Page 99 and 100: 3.4 CLEANING (CONT). m. Clean outsi
Page 101 and 102: APPENDIX A REFERENCES A-1. SCOPE. T
Page 103 and 104: APPENDIX B COMPONENTS OF END ITEM A
Page 105 and 106: B-3. EXPLANATIONS OF COLUMNS (CONT)
Page 107 and 108: APPENDIX C ADDITIONAL AUTHORIZATION
Page 109 and 110: SECTION II. ADDITIONAL AUTHORIZATIO
Page 111 and 112: D-2. EXPLANATION OF COLUMNS (CONT).
Page 114: DID WE GOOF? DO YOU KNOW A BETTER W
show all

technical manual operator instructions

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?