technical manual operator instructions

More documents

Recommendations

Info

2.7.1 CONNECTING THE DRINKING SYSTEM (CONT). c. Push on outlet valve cover (2) and grasp internal drink tube between your teeth. d. Flip open cover (3) on M1 canteen cap. e. Push external drink tube coupling (5) into M1 canteen cap (4) so that pin (6) enters coupling (5). f. Blow to create positive pressure. You should feel some resistance. If resistance is not felt, your drinking system is leaking. Do not drink. g. If system leaks (no resistance), pinch and hold drink tube and see unit maintenance immediately. 2-49
2.7.1 CONNECTING THE DRINKING SYSTEM (CONT). h. If system does not leak, tilt up canteen and drink. i. After several swallows, stop sucking and lower canteen. Blow into internal drink tube to prevent canteen from collapsing. Repeat drinking procedure as required. 2-50
Page 1 and 2:
TM 3-4240-341-10 TECHNICAL MANUAL O
Page 3 and 4:
WARNING SUMMARY This publication de
Page 5 and 6:
WARNING SUMMARY (CONT) o You must c
Page 7 and 8:
EXPLANATION OF SINGLE HAZARD SYMBOL
Page 9 and 10:
HEALTH/ENVIRONMENTAL HAZARD Filter
Page 11 and 12:
TABLE OF CONTENTS (CONT) APPENDIX A
Page 13 and 14:
Fig 1. Mask, Chemical-Biological: M
Page 15 and 16:
SECTION I. GENERAL INFORMATION (CON
Page 17 and 18:
SECTION I. GENERAL INFORMATION (CON
Page 19 and 20:
SECTION II. EQUIPMENT DESCRIPTION A
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28: SECTION III. THEORY OF OPERATION (C
Page 29 and 30: SECTION III. THEORY OF OPERATION (C
Page 31 and 32: 2.1.1 General (CONT). a. Perform PM
Page 33 and 34: 2.1.2 PMCS Procedures (CONT). f. Th
Page 35 and 36: Table 2-1. PREVENTIVE MAINTENANCE C
Page 67 and 68: 2.2 MANDATORY REPLACEMENT PARTS. Th
Page 69 and 70: 2.4 DONNING YOUR MASK (CONT). c. Pu
Page 71 and 72: 2.4 DONNING YOUR MASK (CONT). f. Bl
Page 73 and 74: 2.5 FIT CRITERIA. a. Verify the fit
Page 75 and 76: 2.6 PUTTING YOUR MASK ON IN COLD WE
Page 77: 2.7.1 CONNECTING THE DRINKING SYSTE
Page 81 and 82: 2.8 REMOVING YOUR MASK. a. Disconne
Page 83 and 84: 2.9 STOWING YOUR MASK AND ADDITIONA
Page 85 and 86: 2.9 STOWING YOUR MASK AND ADDITIONA
Page 87 and 88: 2.10 WEARING YOUR MASK CARRIER (CON
Page 89 and 90: 2.12 INSTALLATION OF HOOD. a. Remov
Page 91 and 92: 2.13 WEAR AND LOCATION OF THE CANIS
Page 93 and 94: No lubrication is required for the
Page 95 and 96: 3.2 CHECKING YOUR MASK FOR LEAKS (C
Page 97 and 98: 3.4 CLEANING (CONT). c. Soak brush
Page 99 and 100: 3.4 CLEANING (CONT). m. Clean outsi
Page 101 and 102: APPENDIX A REFERENCES A-1. SCOPE. T
Page 103 and 104: APPENDIX B COMPONENTS OF END ITEM A
Page 105 and 106: B-3. EXPLANATIONS OF COLUMNS (CONT)
Page 107 and 108: APPENDIX C ADDITIONAL AUTHORIZATION
Page 109 and 110: SECTION II. ADDITIONAL AUTHORIZATIO
Page 111 and 112: D-2. EXPLANATION OF COLUMNS (CONT).
Page 114: DID WE GOOF? DO YOU KNOW A BETTER W
show all

technical manual operator instructions

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?