Dolby LM100 Broadcast Loudness Meter User's Manual

Getting Started
The remote response from the unit is fastest at 115,200 baud, so we recommend using that
rate if possible. The unit does support slower communication rates. The unit address is
only important when more than one LM100 is attached to the same serial port. Contact
your technical support representative if you need assistance with unit addressing.
You can change the default remote operation settings from the unit front panel on the
System Settings portion of the Setup menu. Follow these steps.
1. At the main status screen, press Setup.
2. At the main Setup menu, press until the highlighted item on the LCD second line
reads System Settings (six times).
3. Press Enter.
4. Press . The second line reads Baud Rate. Press Enter if you need to change it.
Then press until the baud rate you wish to use is highlighted in the display. Press
Enter. Then press Esc to return to System Settings.
5. Press twice. The second line reads Unit Address. Press Enter if you need to
change it.
6. Use the arrow keys enter a new unit address. Then press Enter to commit to the new
address.
2.8.5 Beginning and Ending Remote Operation
To begin remote operation, on the LM100 unit front panel, press and release Shift once so
that the key lights up, then press •. While in remote mode, •(labeled Remote) glows, and
setup commands cannot be made using the unit front panel. Status displays remain
accurate in remote mode.
To end remote operation, press Shift then • again.
2.8.6 Starting the Universal Remote Software
To start the remote software in Windows:
1. Go to Programs > Dolby Laboratories > Universal Remote.
2. Click Universal Remote.
The machine displays the main application screen shown in Figure 2‐5.
10 Dolby ® LM100 Broadcast Loudness Meter User’s Manual