XR1267 - Xtreme Manufacturing
XR1267 - Xtreme Manufacturing
XR1267 - Xtreme Manufacturing
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>XR1267</strong><br />
Operator Cab<br />
Warning<br />
DO NOT adjust the seat or seat belt while<br />
the forklift is moving. Keep both hands on<br />
the wheel while the forklift is moving to<br />
prevent loss of forklift control which could<br />
result in death or serious injury.<br />
Before starting the engine, adjust the seat for position and<br />
comfort (refer to the Operator Seat section of this manual)<br />
and then adjust the seat belt as follows:<br />
1. Grasp the free end of the seat belt (located on the left<br />
side of the seat) and make sure the belt webbing is<br />
not twisted or entangled in any portion of the seat<br />
assembly.<br />
2. Pull the retractable seat belt across your lap. Position<br />
the seat belt as low on your body as possible.<br />
3. Insert the latch plate into the buckle (on the right side<br />
of the seat) until a “click” is heard.<br />
4. Make sure seat belt retracts snugly across your lap.<br />
Controls and Indicators<br />
Travel Select Lever<br />
The travel select lever has three (3) positions:<br />
FORWARD, NEUTRAL, and REVERSE, which change the<br />
direction of travel.<br />
Position<br />
Purpose<br />
Table 6. Travel Select Lever<br />
F Forward UP Position (Away from the operator).<br />
N Neutral CENTER Position.<br />
R Reverse DOWN Position (Toward the operator).<br />
Rear View Mirrors<br />
Two (2) adjustable rear view mirrors are provided to aid<br />
the operator’s rear vision. One (1) rear-view mirror is<br />
mounted on the upper left of the operator’s cab.<br />
Figure 6-16. Travel Select Lever.<br />
The travel select lever automatically locks when it is in the<br />
NEUTRAL position. The operator must raise and move<br />
the travel select lever when changing to the FORWARD or<br />
REVERSE position.<br />
NOTE: The travel select lever must be in the<br />
NEUTRAL position to start the reach forklift.<br />
NOTE: The back-up alarm automatically sounds when the<br />
travel select lever is in the REVERSE position.<br />
Figure 6-14. Cab-Mounted Mirror.<br />
Figure 6-15. Frame Mounted Mirror.<br />
For information call (800) 497-1704 Page 37