Policy Framework Configuration Guide - Juniper Networks

Chapter 7: Summary of Routing Policy Configuration Statements
policy-statement
Syntax policy-statement policy-name {
term term-name {
from {
family family-name;
match-conditions;
policy subroutine-policy-name;
prefix-list prefix-list-name;
prefix-list-filter prefix-list-name match-type ;
route-filter destination-prefix match-type ;
source-address-filter source-prefix match-type ;
}
to {
match-conditions;
policy subroutine-policy-name;
}
then actions;
}
}
Hierarchy Level
[edit dynamic policy-options],
[edit logical-systems logical-system-name policy-options],
[edit policy-options]
Release Information Statement introduced before Junos OS Release 7.4.
Statement introduced in Junos OS Release 9.0 for EX Series switches.
Support for configuration in the dynamic database introduced in Junos OS Release 9.5.
Support for configuration in the dynamic database introduced in Junos OS Release 9.5
for EX Series switches.
inet-mdt option introduced in Junos OS Release 10.0R2.
Description
Define a routing policy, including subroutine policies.
Options
actions—(Optional) One or more actions to take if the conditions match. The actions are
described in “Configuring Flow Control Actions” on page 49.
family family-name—(Optional) Specify an address family protocol. Specify inet for IPv4.
Specify inet6 for 128-bit IPv6, and to enable interpretation of IPv6 router filter
addresses. For IS-IS traffic, specify iso. For IPv4 multicast VPN traffic, specify
inet-mvpn. For IPv6 multicast VPN traffic, specify inet6-mvpn. For
multicast-distribution-tree (MDT) IPv4 traffic, specify inet-mdt.
NOTE: When family is not specified, the routing device uses the default IPv4
setting.
from—(Optional) Match a route based on its source address.
Copyright © 2010, Juniper Networks, Inc.
177