H.264 Network DVR User Manual - Supercircuits Inc.

More documents

Recommendations

Info

SECTION 4: DVR SOFTWARE USAGE Table 2. Detection area setup Transparent block indicates an area monitored for detection. Press ENTER to confirm the start area. Use the t and/or u buttons to choose the width of the detection area. Use the p and/or q buttons to choose the height of the area. You can also set up multi-detection area. When any movement is detected, the grids are flashing. • LS – Level of Sensitivity (on selected models). Use LS to set the sensitivity for comparing two different images. A small value represents a high sensitivity for motion detection. 24 www.supercircuits.com
SECTION 4: DVR SOFTWARE USAGE • SS – Spatial Sensitivity (on selected models). Use SS to set the sensitivity for detecting the size of one object (the number of the grids) on the screen. A small value represents a higher sensitivity for motion detection. NOTE The SS number represents the least number of blocks in which motion is detected for the system to trigger recording. For example, if SS is 05 and motion is detected in 5 or more blocks, a record trigger will occur. The default SS value is 03. • TS – Time of Sensitivity (on selected models). TS represents how long an object stays in the detection area before triggering a recording. Depending on the model, one of the following options is used: —— Select a value. A small value represents a high sensitivity for motion detection. —— Select either HIGH or NORMAL. • RE – Reference (on selected models). RE sets a reference for detection. With the default value of 10, the DVR will compare 10 continuous images at one time using the parameters LS, SS, and TS. • ALARM (selected models). Select N.C. (normally closed) or N.O. (normally open) to match the alarm switch design, or select OFF (default). 4.5.3 Alert Use this menu to enable audible alerts when various system conditions occur. Move to ALERT then press ENTER to open the ALERT menu. H.264 Network DVR User Manual 25
Page 1 and 2: H.264 Network DVR User Manual Produ
Page 3 and 4: Table of Contents SECTION 1 Product
Page 5 and 6: TABLES OF CONTENTS SECTION 7 Specif
Page 7 and 8: SECTION 1: PRODUCT DESCRIPTION SECT
Page 9 and 10: SECTION 2: FRONT AND REAR PANEL CON
Page 11 and 12: SECTION 2: FRONT AND REAR PANEL CON
Page 13 and 14: SECTION 3: CONNECTIONS AND SETUP SE
Page 15 and 16: SECTION 3: CONNECTIONS AND SETUP >
Page 17 and 18: SECTION 3: CONNECTIONS AND SETUP >
Page 19 and 20: SECTION 3: CONNECTIONS AND SETUP iv
Page 21 and 22: SECTION 4: DVR SOFTWARE USAGE ADVAN
Page 23 and 24: SECTION 4: DVR SOFTWARE USAGE The Q
Page 25 and 26: SECTION 4: DVR SOFTWARE USAGE • D
Page 27 and 28: SECTION 4: DVR SOFTWARE USAGE 4.4.5
Page 29: SECTION 4: DVR SOFTWARE USAGE CAMER
Page 35 and 36: SECTION 4: DVR SOFTWARE USAGE NOTE
Page 37 and 38: SECTION 4: DVR SOFTWARE USAGE Subme
Page 39 and 40: SECTION 4: DVR SOFTWARE USAGE 4.6 S
Page 43 and 44: SECTION 4: DVR SOFTWARE USAGE 4.8 B
Page 45 and 46: SECTION 4: DVR SOFTWARE USAGE • C
Page 47 and 48: SECTION 5: BASIC OPERATION SECTION
Page 49 and 50: SECTION 5: DVR SOFTWARE USAGE —
Page 51 and 52: SECTION 6: LOCAL AND REMOTE OPERATI
Page 79 and 80: SECTION 7: SPECIFICATIONS SECTION 7
Page 81 and 82:
APPENDIX A: D-SUB CONNECTOR PIN CON
Page 83 and 84:
APPENDIX A: D-SUB CONNECTOR PIN CON
Page 85 and 86:
APPENDIX C: COMPATIBLE HDD MODELS A
Page 87 and 88:
APPENDIX D: TROUBLESHOOTING FAQ Que
Page 89 and 90:
APPENDIX E: RS232 PROTOCOL Function
Page 91 and 92:
APPENDIX G: RECORDING TIME TABLE AP
show all

H.264 Network DVR User Manual - Supercircuits Inc.

Create successful ePaper yourself

Delete template?

Save as template?