1 Überschrift 1 - Audio Intervisual Design, Inc.

2.3.4 Important Hints for Installation
2.3.4.1 DC Lines between Rectifier and Lamphouse
ATTENTION
To avoid errors:
• keep wire length as short as possible and put rectifier under / beside lamp
house
• a proper and efficient shielding of both DC wires is required, e. g. steel pipe
• keep any other lines away from DC lines as far as possible
2.3.4.2 Concerning Audio Wiring and Trip Lines
ATTENTION
To avoid errors:
• all wire ducts and trip lines are to be lead in a distance of at least one meter in
parallel to any other (power) lines
• all unavoidable wire crosses and trip line (e. g. to remotes) crosses are to be
lead in an angle of 90°.
2.3.4.3 Power Connections
ATTENTION
• The 50 2 PE lines have to be high-flexible to derive the high-frequency ignition
voltage (see figure 2-2).
• Do not use wires in lamphouse cable to connect the additional dowser.
Lay dowser connection in lamphouse tube as short as possible.
• Do not use unit parts as climbing aid.
• If you install an old building projector remove all not used cables, wires and
lines under projector.
2-10
Issue: 10/2003