1 Überschrift 1 - Audio Intervisual Design, Inc.

3. Put on the film reel with the sound track forwards.
4. Screw on the knurled nut until you feel a light resistance.
5. Flap film guiding arm before the film reel.
HINWEIS
• Use only exactly true running bobbies.
• The film reel should not touch the film guide brackets and arms.
• Running a 35 mm film the film guiding arms and the film guide brackets
have to be in the pull-out position. Running a 16 mm film both have to be
snapped-in.
• Adjusting the friction end stages, see EC service manual.
3.2.6.2 Pendulum Rollers
The pendulum rollers serve for balancing and stabilizing the film run between the
film reels and the feed sprocket or the bottom sprocket.
5
4
1
1
pendulum rollers
spring guide slits
Figure 3-29
Pendulum roller unit
rectangular spring flange set-screws
Adjusting
If you state a play in the pendulum unit you have to re-bend the rectangular
spring (on backside):
1. Loosen both set-screws in the flange of the pendulum rollers.
2. Pull out the rectangular spring and lightly bend the free ends of the spring
inwards by means of a flat-noise pliers.
3. Insert the spring in a way, that it sits close in the slits and terminates with the
outside edge of the pendulum rollers.
4. Fix the spring by tightening the set-screws .
NOTE
Every half year the spring guide slits have to be oiled by a non-corrosive oil (e. g.
Esso universal oil).
3-32
Issue: 10/2003