User Manual - Visionary Forces

CHANGING CAMERA SETTINGS
USING CAMERA LCD / EXTERNAL MONITOR AS REFERENCE
To adjust a parameter value displayed on the camera’s Upper Status Group, first note the red colored
bar (located under 24fps in this example), indicating the currently active parameter for instant
adjustment.
Use the NAVIGATION GROUP directional pad to move the cursor to a different parameter if desired,
then press the ENTER key to select that parameter and use the Scroll Wheel to adjust that parameter’s
value. To confirm the change in parameter value and to exit the adjustment menu, press the ENTER
button.
To access the camera’s menus, press the MENU button at the lower left. The MENU displays on the
EVF, LCD or external monitors if the LCD and/or EVF are not connected disconnected.
Use the NAV GROUP to make changes to the cameras settings. Use the scroll wheel and directional
pad to move the cursor to navigate and make changes to the desired settings. When a desired setting
change is made, press the ENTER button or the directional pad UP arrow to exit from that setting.
Exiting Menus to Main Screen
To EXIT from the Secondary Menus and return to the main screen:
Press the MENU button until the main screen is displayed.
USING REDMOTE LCD STAND-ALONE
The LOCAL function of the REDMOTE allows you to adjust the camera settings from the REDMOTE
while observing the parameters directly on the REDMOTE LCD as opposed to on the camera LCD or an
external monitor. For complete details refer to REDMOTE MENUS > SOFT MENU BUTTONS 1-3 > 2
REMOTE > LOCAL.
182
COPYRIGHT © 2012 RED Digital Cinema
955-0002_v3.2, Rev-A1