Tata Indicab - Tata Motors Customer Care

MAINTENANCE & CAR CARE
Clutch & Brakes
screw, allow it to return slowly.
6. Wait for 3-4 seconds before next stroke.
7. Repeat until bubbles stop emanating from bleed tube.
8. Close bleed screw immediately after the last downward stroke of
pedal and hold pedal.
9. Tighten bleed screw and remove tube.
10. Replace dust cap on bleed screw.
11. Repeat same procedure on rear right, front right and then rear left.
12. If bleeding continues without success it means air is being drawn
in past the bleed screw threads.
13. Close bleed screw at the end of each downward stroke of pedal.
14. Allow pedal to return fully and slowly.
15. Tighten bleed screw finally after last downward stroke of pedal .
16. Replace the dust cap on the bleed screw.
17. Apply brake pedal hard and check for any leaks.
3
Front
1
2
Rear
4
90