INSTALLATION MANUAL

More documents

Recommendations

Info

General information Contacts Guide • Proceeding with installation Position and switch on the Access Point at the centre of gravity with the printers. With the laptop PC and a USB to Wireless converter installed on board, check Link Quality and signal strength in the zones where the printers will be installed and in the zone where the PC is located. The Link Quality and Signal Strength bars indicate the quality of the wireless section. The minimum acceptable values of these two parameters are around 60-70% Swing 5.i – Connecting to computer and data exchange 36
General information Contacts Guide • In order to check the quality of the link the command “ping nnn.nnn.nnn.nnn – t” should also be run from the Ms-Dos prompt of Windows. nnn.nnn.nnn.nnn is the IP address of the Access Point and enables the send/receive test of 32-byte packets between the PC and the Access Point to be tested, showing dispatch and return times. The monitor displays the result of each ping command prompt: Ping (Packet InterNet Groper i.e. "Internet package searcher") is a programme that is available in the main operating systems that measures the time, expressed in milliseconds taken by one or more ICMP packets (transmission protocols) to reach another computer or network server (whether Internet or LAN) and return to the origin.Itisinfactaservice run by the server, locally or via Internet, to find out whether the server is operating. Swing 5.i – Connecting to computer and data exchange 37
Page 1 and 2: Code: RT542 Rev. D1 INSTALLATION MA
Page 3 and 4: General information Contacts Guide
Page 35: General information Contacts Guide
Page 39 and 40: General information General informa
Page 41: Guide Guide Surfing Contents t From

INSTALLATION MANUAL

Create successful ePaper yourself

Delete template?

Save as template?