INSTALLATION MANUAL

More documents

Recommendations

Info

General information Contacts Guide Remember ! Positioning. If it is not possible to install the printer with the print surface integral with it, the print surface should be installed with the rubber at a maximum distance of 2.5-3mm from the head profile. Allow provision for setting the print surface with respect to the head so as to facilitate the search for the optimum print condition. Leave sufficient space for internal maintenance of the machine (rear cover). If this accessibility cannot be guaranteed, fit the machine to a support that enables the operator to rotate it or slide it to a comfortable position. To clean the head, the printer does not need to be moved away from the print head. This operation is on the other hand recommended if the print head has to be replaced. Support. The print unit support must be robust enough to minimize rocking or vibrations. Ambient temperature and humidity. The machine must also be installed in an environment where the temperature is not above 40°C (away from any drying kilns, etc.) and not below +5°C and with humidity not above 70%. Swing 5.i – Positioning printer 8
General information Contacts Guide Obey these notices carefully to avoid creases forming on the printed surface A B The print unit print must be fixed to the packaging line. Position the two points [A] and [B] parallel. Check with a spirit level! The printer does not need to be in a completely horizontal position. But it is VERY important that the two sides are parallel to one another. Swing 5.i – Positioning printer 9
Page 1 and 2: Code: RT542 Rev. D1 INSTALLATION MA
Page 3 and 4: General information Contacts Guide
Page 7: General information Contacts Guide
Page 39 and 40: General information General informa
Page 41: Guide Guide Surfing Contents t From

INSTALLATION MANUAL

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?