CEREC MC XL - MEDIPRO
CEREC MC XL - MEDIPRO
CEREC MC XL - MEDIPRO
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Sirona Dental Systems GmbH<br />
Operating Instructions <strong>CEREC</strong> <strong>MC</strong> <strong>XL</strong><br />
6 Operation<br />
Preparing optical scanning (only with integrated scanner)<br />
6.5.2 Creating a model<br />
✔<br />
NOTICE<br />
KwikkModel as modeling compound<br />
The following instructions are based on the use of KwikkModel ® as a<br />
modeling compound. KwikkModel is a registered trademark of the R-<br />
dental Dentalerzeugnisse GmbH.<br />
An impression with alginate, hydrocolloid or polyether is made (see<br />
operating instructions for casting materials).<br />
1. Fill the impression with the modeling compound (see operating<br />
instructions for modeling compound).<br />
NOTICE<br />
Observe the position and insertion axis<br />
The prepared tooth should lie as near the center of the model holder as<br />
possible. Make sure the model holder is positioned vertically to the<br />
insertion axis.<br />
båÖäáëÜ<br />
2. Within 10 seconds press the model holder on the compound.<br />
3. Let the compound harden for about 2 minutes.<br />
4. Remove the model holder with the model from the form.<br />
NOTICE<br />
Using polyether, let the model cure for about two minutes (see also the<br />
operating instructions for the modeling compound).<br />
5. With a scalpel cut away the areas unnecessary for the scanning process.<br />
61 46 885 D 3439<br />
D 3439.201.02.11.02 10.2009 33