Technical Specification - UNDP

1 GENERAL
1.1 Scope of Work
The work to be included in these specifications will be as mentioned in the
standard bidding documents
1.2 Drawings
1.2.1 Tender Drawings
A number of Contract Drawings available at the date of Tender is included in the List
of Drawings attached to these specifications. All work shall be performed in
accordance (with the Drawings furnished together with the Contract) documents and
any such additional Drawings as may be issued by the Engineer from time to time
during the progress of the work. Additional Drawings, (if any), will be furnished to
the Contractor in due time so as to enable the Contractor to perform the work shown
thereon in its proper sequence and for any advance planning that may be necessary for
the efficient performance of such work. The Engineer will decide in such instance
whether additional Drawings are required for advance planning of the Works and
determine the time required for the same.
All lines, elevations and measurements shown on the drawing are approximate and
are intended to be used for tendering only. It shall be the Contractor's responsibility to
verify and determine the exact lines, grades and elevations to the approval of the
Engineer before commencing any section of the Works.
1.2.2 Shop Drawings
The Engineer shall have authority to order at any time and the Contractor agrees to
provide at his own expense any number of shop drawings which, in the opinion of the
Engineer, are necessary for the proper execution of a specified work. The Contractor
shall not proceed with the above mentioned work unless these shop drawings are
approved by the Engineer.
1