AIR CONDITIONING

5.2 Start - C7000 Advanced
After having switched on the power supply of the C7000 Advanced the window
at the right side will appear. On this window the maximum number of 32 bus
participants (bus-ID 0 - 31) are displayed by symbols which are located in 8
columns and 4 lines. An I/O controller is displayed by a square frame with an
indication of the local temperature and humidity in integer values. A grey frame
signifies that the unit is in a stop state, a black frame indicates that the unit is
in operation. An IOC symbol without measured values indicates that the IOC is
not reachable; e.g. because it is switched off (no voltage) or due to a bus fault.
The other symbols contain an abbreviation for the controller type: PT - C7000
Plus Terminal, PT2 - C7000 Plus Terminal2, AT - C7000 Advanced Terminal,
ME - C7000AT at which these windows are actually displayed.
The bus-ID can be deducted from the location in the scheme. Line 1 contains
the bus participants 0 - 7 from left to right, line 2: 8-15, line 3: 16-23, line 4:
24-31.
A space signifies that a unit with a corresponding bus-ID does not exist.
A symbol/unit which is selected, is displayed inversely. In the window on top of
the page the C7000AT is selected. It appears inversely with white letters on a
black background. In the window below, the C7000IOC is selected.
The context status line contains the bus-ID and the global address of the
selected bus participant.
The global status line contains the Stulz logo, the bus-ID and global address
of the AT from which you operate and the clock.
context status line
global status line
With the selector key you can choose the unit which you want to control. After
having marked the last bus participant position 31 you get to the following
display, with the selector key, where all units are marked. In this state you can
switch on/off the whole system by the local on/off key.
If some units are in operation, all units are switched off if you press the on/off
key. Then, with the second key activation all units are switched on.
If you press the OK-button when all positions are marked the checkbus function
is carried out (after the request and entry of the service master password).
Getting further with the selector key brings you via the Stulz logo to the bus-ID
of the AT which you have the possibility to adjust (after the request and entry
of the service master password) and to the global address which cannot be
adjusted here, for safety reasons.
Finally you can adjust the time by selecting the clock.
The following items can be adjusted in sequence:
bus-ID
global address
- Year
- Month
- Day
- Hour
- Minute
- Second
E/1006/57/27