Untitled - HUBER
Untitled - HUBER
Untitled - HUBER
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2.1 Abbreviating keys<br />
unistat control V3.8.1<br />
You often find the instruction in the text to press a key. The used abbreviation is always the<br />
„“ brackets. The instruction to press „0„ will look like this: <br />
Because of the danger of confusion the red key at the bottom of the controller (the 0-key)<br />
will be called in the instructions: <br />
is for the RAMP function, for ‘Set’ and so on.<br />
2.2 Display Information<br />
You can program the Unistat Control in one of three languages (German, English and French).<br />
Simple text that is understandable in all languages is displayed in one language.<br />
The display language is set using program 90.<br />
2.3 Fault<br />
Important occurrences are saved with date and hour in a long-term memory. With program 10<br />
and Appendix B incidents like Start/Stop of thermoregulation or any failure of unit can be<br />
interpreted.<br />
3. Physical Structure<br />
The control electronics of the unistat control is accommodated in a separate detachable<br />
housing. It is therefore possible to apply the valuable „Plug & Play“ philosophy which has<br />
been part of Huber equipment for many years. It is also possible to use it in the new<br />
generations of Unistats. Unistat control consists of two units: the electronic controller and<br />
the control panel placed in a recess in the housing.<br />
The control panel can be detached from the controller (a screw from above) and the<br />
electronic connection to the controller can be made with a special cable (Order No 6147).<br />
If the control panel is to be used via a cable connection, reference should be made to the<br />
paragraph ‘Remote Control’.<br />
3.1 Removing the Control Panel<br />
1) Turn off tempering and circulation by pressing key, turn off mains switch on<br />
unit.<br />
Switch off main switch on chillers<br />
2) Unplug from mains.<br />
3) Remove cover from fixing screw (picture 2 see drawing at the last page).<br />
For chillers: Remove the cover of plug connector (3 screws) directly behind control<br />
panel.<br />
4) Loosen M3 screw and remove.<br />
5) Tip control panel forward until mounting recess is released (ca 1 cm). Carefully pull the<br />
control panel up and out of its recess.<br />
3.2 remove unistat controller<br />
1) Follow all steps as explained in ‘remove control panel’.<br />
2) Loosen screw ‘fixing unistat controller’ (picture 2 see drawing at the last page)<br />
3) The housing is still connected to the unit via a plug connector.<br />
4) Pull housing vertically up.<br />
3