Parameter List Edition 04/03 SINAMICS G110 - Automatyka Siemens

04/03 Parameters
1 Parameters
1.1 Introduction to SINAMICS G110 System Parameters
The layout of the parameter description is as follows.
1 Par number 2 Parameter name 9 Min:
[index] 3 CStat: 5 Datatype: 7 Unit: 10 Def:
4 P-Group: 6 Active: 8 QuickComm.: 11 Max:
12 Level:
2
13 Description:
1. Parameter number
Indicates the relevant parameter number. The numbers used are 4-digit numbers
in the range 0000 to 9999. Numbers prefixed with an “r” indicate that the
parameter is a “read-only” parameter, which displays a particular value but cannot
be changed directly by specifying a different value via this parameter number (in
such cases, dashes “-“ are entered at the points “Unit”, “Min”, “Def” and “Max” in
the header of the parameter description.
All other parameters are prefixed with a “P”. The values of these parameters can
be changed directly in the range indicated by the “Min” and “Max” settings in the
header.
[index] indicates that the parameter is an indexed parameter and specifies the
number of indices available.
2. Parameter name
Indicates the name of the relevant parameter.
The BICO system is not available with the SINAMICS G110 inverter. To allow the
parameter names to be used across a variety of inverter types, the names of
parameter have not been changed.
3. Cstat
Commissioning status of the parameter. Three states are possible:
♦ Commissioning C
♦ Run
U
♦ Ready to run T
This indicates when the parameter can be changed. One, two or all three states
may be specified. If all three states are specified, this means that it is possible to
change this parameter setting in all three inverter states.
4. P-Group
Indicates the functional group of the particular.
Note
Parameter P0004 (parameter filter) acts as a filter and focuses access to
parameters according to the functional group selected.
Parameter List SINAMICS G110
6SL3298-0BA11-0BP0 7