User Manual - Mede8er.org

WIRELESS USB DONGLE INSTALLATION (After Market)
The X3 is only compatible with the optional (unless otherwise stated on the packaging) Mede8er Wireless
Dongle MED10WFB. (Other brands will not work)
Refer to User Instructions supplied with the Mede8er dongle for detailed wireless connection setup.
WIRELESS NETWORK CONNECTION
Plug the WiFi Dongle into the USB extension base that was supplied with the MED10WFB. Plug the USB
cable into one of the USB host ports on the side of the X3. Extend the cable and place the base in a
position that is away from any metal object that could effect the Radio Frequency signal strength. The best
placement for the WiFi Dongle will depend on your particular environment. In order to get the best
placement you may need to extend the length with an additional USB extension cable.
MED10WFB
USB Host Port
WIRELESS PCIE ANTENNA INSTALLATION (Factory Fit)
Certain models of the X3 (depending on the region) may be available with a factory fitted PCIE WiFi kit.
Check the packaging information to confirm if your model has the pre installed WiFi Kit.
Screw the antenna into the SMA antenna
connector on the X3. Twist the antenna
gently into the vertical position as shown.
SMA Antenna Connector
PCIE Antenna
The operating distance or range of your wireless connection can vary significantly based on the physical
placement of the Router and the WiFi Dongle or PCIE antenna.
For best results, place your Router:
* Near the center of the area in which your X3 will operate.
* In an elevated location such as a high shelf.
* Away from potential sources of interference, such as PCs, microwaves, and cordless phones.
* The Antenna should be screwed in tight and in the upright position.
* Away from large metal surfaces.
Page15