User Manual - AMS Neve

SynchroNet ES/2 User Guide
ES/2 Operations Reference
Offset Trim Menu
DIGIT scan< +00.00.00.00 up +
SLEW +and- OFFSET TRIM MENU down -
LOAD
press
The Offset Trim Menu allows the offset to be adjusted either by incrementing or decrementing the
selected digit of the offset, and then pressing the LOAD key, or by slewing the machine.
The four keys are:
SLEW
To slew the offset value
Press the SLEW key at the same time as either the + or - key.
The key does NOT auto repeat.
To slew many frames or sub-frames
Hold the SLEW key and repeatedly press the + or - keys.
If you wish to slew or trim the sub-frame part of the offset
DIGIT
Turn the SUB-F (sub-frames) option ON within the Offset Main Menu before entering the
Offset Trim Menu.
The DIGIT key moves the cursor to the next digit to the left. This allows you to use the + and - keys to
increment or decrement each digit of the displayed value. The displayed value does not become
active until confirmed by pressing the LOAD button.
Negative offset values may be entered by moving the cursor to the sign position to the left of the
displayed value and using + or - to change the sign. On loading a negative value, note that it will be
converted to a 24 hour standard value.
LOAD
The LOAD key appears (in the position normally occupied by SLEW) when the DIGIT SCAN, + or -
buttons have been used. When operated, it loads the displayed offset and returns the display to the
Offset Main Menu.
+/-
The + and - keys operate in conjunction with SLEW and DIGIT.
Issue 2 3:13