899883192 - Valiant

More documents

Recommendations

Info

Section 5 - Maintenance 2. Remove the IAC muffler. IAC muffler installed in the IAC adapter 3. Inspect the IAC muffler for holes, cracks, or deterioration. Replace the IAC muffler if damaged. IMPORTANT: Do not get cleaner on electrical connections and do not use cleaner containing methyl ethyl ketone. 4. Clean the IAC muffler with warm water and a mild detergent. Replace if necessary. 5. Allow the IAC muffler to completely, then install. Water‐Separating Fuel Filter ! WARNING Fuel is flammable and explosive. Ensure the key switch is off and the lanyard is positioned so that the engine cannot start. Do not smoke or allow sources of spark or open flame in the area while servicing. Keep the work area well ventilated and avoid prolonged exposure to vapors. Always check for leaks before attempting to start the engine and wipe up any spilled fuel immediately. ! CAUTION Failure to release pressure from the fuel system will result in fuel spraying out, which can cause a fire or explosion. Allow the engine to cool completely and release all fuel pressure before servicing any part of the fuel system. Always protect eyes and skin from pressurized fuel and vapors. 33269 Page 78 90-<strong>899883192</strong> NOVEMBER 2008
Section 5 - Maintenance GEN III Models d c e b h f g a a - Cool Fuel Module b - Cool Fuel Module harness c - Filter cap d - Filter assembly retaining screw 8837 e - Fuel filter element f - Filter cup g - Cool Fuel Module filter reservoir h - O‐ring REMOVAL 1. Allow the engine to cool down. NOTE: Mercury MerCruiser recommends that the engine be shut off for 12 hours prior to filter removal. 2. Close fuel supply valve, if equipped. 3. Disconnect the Cool Fuel Module harness from the engine wiring harness. 4. Turn the key switch to the start position and allow the starter to operate for 5 seconds. 5. Turn key switch to off position. 6. Loosen each filter assembly retaining screw until the screw is disengaged from the Cool Fuel Module. Do not remove the filter assembly retaining screws from the filter cap. 7. Unseat the filter assembly by grasping the filter assembly handle and pulling upward. Do not remove the filter assembly from the Cool Fuel Module at this time. 8. Allow any fuel that may be in the filter assembly to drain out through the bottom of the filter assembly and into the Cool Fuel Module filter reservoir. 9. Remove the filter cup from the filter cap by grasping the filter cap and rotating it in a clockwise direction while holding the filter cup stationary. 10. Remove the used water‐separating fuel filter element from the filter cup, place it in a clean, approved container. 11. Dispose of any water or debris that may be in the filter cup. 90-<strong>899883192</strong> NOVEMBER 2008 Page 79
Page 1 and 2:
NOTE: The following applies to CE m
Page 3 and 4:
Welcome You have selected one of th
Page 5 and 6:
TABLE OF CONTENTS Section 1 - Warra
Page 7 and 8:
Checking...........................
Page 9 and 10:
Table of Contents Section 1 - Warra
Page 11 and 12:
Transfer of Warranty Section 1 - Wa
Page 13 and 14:
Section 1 - Warranty Conditions Tha
Page 15 and 16:
Global Warranty Charts Section 1 -
Page 17 and 18:
Warranty for Government Application
Page 19 and 20:
Warranty for Government Application
Page 21 and 22:
Commercial Application Warranty Cha
Page 23 and 24:
Section 1 - Warranty Mercury MerCru
Page 25 and 26:
How To Obtain Warranty Coverage Wha
Page 27 and 28:
Section 1 - Warranty Disclaimers An
Page 29 and 30:
Owner Responsibility "STD."—Emiss
Page 31 and 32:
Section 2 - Getting to Know Your Po
Page 33 and 34:
Section 2 - Getting to Know Your Po
Page 35 and 36: Instrumentation • consuming alcoh
Page 37 and 38: Section 2 - Getting to Know Your Po
Page 45 and 46: SYNCHRONIZING DUAL HELMS PRIOR TO S
Page 51 and 52: Table of Contents Section 3 - On th
Page 53 and 54: Section 3 - On the Water • Do not
Page 55 and 56: Section 3 - On the Water Operation
Page 57 and 58: Section 3 - On the Water Operation
Page 59 and 60: 1. Refer to Remote Controls section
Page 61 and 62: Section 3 - On the Water Wave and W
Page 63 and 64: Ventilation Section 3 - On the Wate
Page 65 and 66: Section 4 - Specifications Section
Page 67 and 68: Section 4 - Specifications • Corr
Page 69 and 70: Propshaft power Displacement Altern
Page 71 and 72: Propshaft power Displacement Altern
Page 73 and 74: Table of Contents Section 5 - Maint
Page 75 and 76: Section 5 - Maintenance Maintenance
Page 77 and 78: Section 5 - Maintenance Task Interv
Page 79 and 80: Section 5 - Maintenance 1. Remove o
Page 81 and 82: Section 5 - Maintenance 3. Walter V
Page 83 and 84: Section 5 - Maintenance Changing Co
Page 85: Section 5 - Maintenance 11. Install
Page 89 and 90: Transmission Linkage Section 5 - Ma
Page 91 and 92: NEWTONE Section 5 - Maintenance 5.
Page 93 and 94: The Boat Out of the Water Section 5
Page 95 and 96: Section 5 - Maintenance IMPORTANT:
Page 97 and 98: Section 5 - Maintenance 14. Tag the
Page 99 and 100: Table of Contents Section 6 - Stora
Page 101 and 102: Section 6 - Storage 10. For additio
Page 103 and 104: Section 6 - Storage THREE POINT MAN
Page 105 and 106: Section 6 - Storage 14. Before laun
Page 107 and 108: Section 6 - Storage 12. Before laun
Page 109 and 110: Section 6 - Storage Battery Storage
Page 111 and 112: Table of Contents Section 7 - Troub
Page 113 and 114: Engine Will Not Start or Is Hard to
Page 115 and 116: Steering Wheel Jerks or Is Difficul
Page 117 and 118: Section 8 - Customer Assistance Inf
Page 119 and 120: PARTS AND ACCESSORIES INQUIRIES Res
show all

899883192 - Valiant

Create successful ePaper yourself

Delete template?

Save as template?