899883192 - Valiant

More documents

Recommendations

Info

Section 5 - Maintenance b. If not equipped with a seacock, disconnect the seawater inlet hose from the seawater pump inlet fitting and immediately plug the seawater inlet hose to prevent water from siphoning into the engine or boat. 10839 c. Using a suitable adapter, connect the flushing hose from the water source to the water inlet of the seawater pump. d. Proceed to step 3. NOTICE Flushing the engine when it is not operating will result in water collecting in the exhaust system, damaging the engine. Do not supply flush water for more than 15 seconds without the engine operating. 3. Completely open the water source to provide maximum water supply. 4. Place the remote control in the neutral idle speed position. 5. Immediately start the engine. NOTICE Operating the engine out of the water at high speeds creates suction, which can collapse the water supply hose and overheat the engine. Do not operate the engine above 1400 RPM out of the water and without sufficient cooling water supply. 6. Depress the throttle only button and slowly advance the throttle until the engine reaches 1300 RPM (± 100 RPM). 7. Observe the water temperature gauge to ensure that the engine is operating in the normal range. 8. Operate the engine with the transmission in neutral for a minimum of 10 minutes. 9. For power packages operated in salty, brackish, mineral‐laden or polluted water: Continue to operate the engine until the discharge water is clear. 10. Slowly return the throttle to idle speed position. NOTICE Flushing the engine when it is not operating will result in water collecting in the exhaust system, damaging the engine. Do not supply flush water for more than 15 seconds without the engine operating. 11. Stop the engine. 12. Immediately shut off the water supply and remove the flushing attachment. 13. Remove the flushing connector from the water inlet. Page 88 90-<strong>899883192</strong> NOVEMBER 2008
Section 5 - Maintenance 14. Tag the ignition switch with an appropriate tag requiring the seacock to be opened or the seawater inlet hose to be reconnected prior to operating the engine. 15. Repeat the flushing procedure on the next engine, if equipped. 90-<strong>899883192</strong> NOVEMBER 2008 Page 89
Page 1 and 2:
NOTE: The following applies to CE m
Page 3 and 4:
Welcome You have selected one of th
Page 5 and 6:
TABLE OF CONTENTS Section 1 - Warra
Page 7 and 8:
Checking...........................
Page 9 and 10:
Table of Contents Section 1 - Warra
Page 11 and 12:
Transfer of Warranty Section 1 - Wa
Page 13 and 14:
Section 1 - Warranty Conditions Tha
Page 15 and 16:
Global Warranty Charts Section 1 -
Page 17 and 18:
Warranty for Government Application
Page 19 and 20:
Warranty for Government Application
Page 21 and 22:
Commercial Application Warranty Cha
Page 23 and 24:
Section 1 - Warranty Mercury MerCru
Page 25 and 26:
How To Obtain Warranty Coverage Wha
Page 27 and 28:
Section 1 - Warranty Disclaimers An
Page 29 and 30:
Owner Responsibility "STD."—Emiss
Page 31 and 32:
Section 2 - Getting to Know Your Po
Page 33 and 34:
Page 35 and 36:
Instrumentation • consuming alcoh
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46: SYNCHRONIZING DUAL HELMS PRIOR TO S
Page 47 and 48: Section 2 - Getting to Know Your Po
Page 49 and 50: Section 2 - Getting to Know Your Po
Page 51 and 52: Table of Contents Section 3 - On th
Page 53 and 54: Section 3 - On the Water • Do not
Page 55 and 56: Section 3 - On the Water Operation
Page 57 and 58: Section 3 - On the Water Operation
Page 59 and 60: 1. Refer to Remote Controls section
Page 61 and 62: Section 3 - On the Water Wave and W
Page 63 and 64: Ventilation Section 3 - On the Wate
Page 65 and 66: Section 4 - Specifications Section
Page 67 and 68: Section 4 - Specifications • Corr
Page 69 and 70: Propshaft power Displacement Altern
Page 71 and 72: Propshaft power Displacement Altern
Page 73 and 74: Table of Contents Section 5 - Maint
Page 75 and 76: Section 5 - Maintenance Maintenance
Page 77 and 78: Section 5 - Maintenance Task Interv
Page 79 and 80: Section 5 - Maintenance 1. Remove o
Page 81 and 82: Section 5 - Maintenance 3. Walter V
Page 83 and 84: Section 5 - Maintenance Changing Co
Page 85 and 86: Section 5 - Maintenance 11. Install
Page 87 and 88: Section 5 - Maintenance GEN III Mod
Page 89 and 90: Transmission Linkage Section 5 - Ma
Page 91 and 92: NEWTONE Section 5 - Maintenance 5.
Page 93 and 94: The Boat Out of the Water Section 5
Page 95: Section 5 - Maintenance IMPORTANT:
Page 99 and 100: Table of Contents Section 6 - Stora
Page 101 and 102: Section 6 - Storage 10. For additio
Page 103 and 104: Section 6 - Storage THREE POINT MAN
Page 105 and 106: Section 6 - Storage 14. Before laun
Page 107 and 108: Section 6 - Storage 12. Before laun
Page 109 and 110: Section 6 - Storage Battery Storage
Page 111 and 112: Table of Contents Section 7 - Troub
Page 113 and 114: Engine Will Not Start or Is Hard to
Page 115 and 116: Steering Wheel Jerks or Is Difficul
Page 117 and 118: Section 8 - Customer Assistance Inf
Page 119 and 120: PARTS AND ACCESSORIES INQUIRIES Res
show all

899883192 - Valiant

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?