899883192 - Valiant

More documents

Recommendations

Info

Section 5 - Maintenance NOTICE Flushing the engine when it is not operating will result in water collecting in the exhaust system, damaging the engine. Do not supply flush water for more than 15 seconds without the engine operating. 4. Snap the quick connect fitting and the water hose into the flush socket on the engine. V‐drive shown (inline similar) 5. Open the water source completely. 6. Start the engine within 15 seconds. 7. Operate the engine at 1300 RPM, +/‐ 100 RPM. 8. Allow engine to reach normal operating temperature. Watch the temperature gauge on the dash to ensure that the engine does not overheat. 9. Flush the engine for a minimum of 10 minutes or until the discharge water is clear. 10. Shut off the engine. NOTICE Flushing the engine when it is not operating will result in water collecting in the exhaust system, damaging the engine. Do not supply flush water for more than 15 seconds without the engine operating. 33389 11. Turn off water source within 15 seconds of shutting off engine. 12. Disconnect the quick connect fitting and water hose from the flush socket on the engine by pressing the release button on the flush socket 13. Attach to the next engine, if equipped, and repeat procedure. 14. Turn off the water source. 15. Remove the quick connect fitting from the water hose. 16. Replace the blue cap into the flush socket on the engine. 17. Open the seacock, if equipped, or unplug and reconnect the water inlet hose prior to operating the engine. NOTE: If the unit is to be stored in the water, the seacock should remain closed until time of usage. If unit is to be stored out of the water, open the seacock. Page 84 90-<strong>899883192</strong> NOVEMBER 2008
The Boat Out of the Water Section 5 - Maintenance IMPORTANT: Flushing the power package is most effective when performed with the boat out of the water. IMPORTANT: Flushing is needed If the engine package has been operated in salty, brackish, mineral‐laden or polluted water. For best results flushing is recommended after each outing and before cold weather and extended storage. ! WARNING Rotating propellers can cause serious injury or death. Never operate the boat out of the water with a propeller installed. Before installing or removing a propeller, place the drive unit in neutral and engage the lanyard stop switch to prevent the engine from starting. Place a block of wood between the propeller blade and the anti‐ventilation plate. 1. Models with Walter V-Drive Transmissions: a. Close the seacock, if equipped, and then disconnect the seawater inlet hose from the transmission seawater inlet fitting. b. If not equipped with a seacock, disconnect the seawater inlet hose from the transmission seawater inlet fitting and plug the seawater inlet hose. c. Using appropriate connector, connect the flushing water hose to the transmission seawater inlet fitting. d. Proceed to step 3 2. All other models: a. Close the seacock, if equipped, and then disconnect the seawater inlet hose from the seawater pump inlet fitting.. b. If not equipped with a seacock, disconnect the seawater inlet hose from the seawater pump and plug the hose. 6091 10839 90-<strong>899883192</strong> NOVEMBER 2008 Page 85
Page 1 and 2:
NOTE: The following applies to CE m
Page 3 and 4:
Welcome You have selected one of th
Page 5 and 6:
TABLE OF CONTENTS Section 1 - Warra
Page 7 and 8:
Checking...........................
Page 9 and 10:
Table of Contents Section 1 - Warra
Page 11 and 12:
Transfer of Warranty Section 1 - Wa
Page 13 and 14:
Section 1 - Warranty Conditions Tha
Page 15 and 16:
Global Warranty Charts Section 1 -
Page 17 and 18:
Warranty for Government Application
Page 19 and 20:
Warranty for Government Application
Page 21 and 22:
Commercial Application Warranty Cha
Page 23 and 24:
Section 1 - Warranty Mercury MerCru
Page 25 and 26:
How To Obtain Warranty Coverage Wha
Page 27 and 28:
Section 1 - Warranty Disclaimers An
Page 29 and 30:
Owner Responsibility "STD."—Emiss
Page 31 and 32:
Section 2 - Getting to Know Your Po
Page 33 and 34:
Page 35 and 36:
Instrumentation • consuming alcoh
Page 37 and 38:
Page 39 and 40:
Page 41 and 42: Section 2 - Getting to Know Your Po
Page 45 and 46: SYNCHRONIZING DUAL HELMS PRIOR TO S
Page 51 and 52: Table of Contents Section 3 - On th
Page 53 and 54: Section 3 - On the Water • Do not
Page 55 and 56: Section 3 - On the Water Operation
Page 57 and 58: Section 3 - On the Water Operation
Page 59 and 60: 1. Refer to Remote Controls section
Page 61 and 62: Section 3 - On the Water Wave and W
Page 63 and 64: Ventilation Section 3 - On the Wate
Page 65 and 66: Section 4 - Specifications Section
Page 67 and 68: Section 4 - Specifications • Corr
Page 69 and 70: Propshaft power Displacement Altern
Page 71 and 72: Propshaft power Displacement Altern
Page 73 and 74: Table of Contents Section 5 - Maint
Page 75 and 76: Section 5 - Maintenance Maintenance
Page 77 and 78: Section 5 - Maintenance Task Interv
Page 79 and 80: Section 5 - Maintenance 1. Remove o
Page 81 and 82: Section 5 - Maintenance 3. Walter V
Page 83 and 84: Section 5 - Maintenance Changing Co
Page 85 and 86: Section 5 - Maintenance 11. Install
Page 87 and 88: Section 5 - Maintenance GEN III Mod
Page 89 and 90: Transmission Linkage Section 5 - Ma
Page 91: NEWTONE Section 5 - Maintenance 5.
Page 95 and 96: Section 5 - Maintenance IMPORTANT:
Page 97 and 98: Section 5 - Maintenance 14. Tag the
Page 99 and 100: Table of Contents Section 6 - Stora
Page 101 and 102: Section 6 - Storage 10. For additio
Page 103 and 104: Section 6 - Storage THREE POINT MAN
Page 105 and 106: Section 6 - Storage 14. Before laun
Page 107 and 108: Section 6 - Storage 12. Before laun
Page 109 and 110: Section 6 - Storage Battery Storage
Page 111 and 112: Table of Contents Section 7 - Troub
Page 113 and 114: Engine Will Not Start or Is Hard to
Page 115 and 116: Steering Wheel Jerks or Is Difficul
Page 117 and 118: Section 8 - Customer Assistance Inf
Page 119 and 120: PARTS AND ACCESSORIES INQUIRIES Res
show all

899883192 - Valiant

Create successful ePaper yourself

Delete template?

Save as template?