Download - TDK-Lambda

Front panel description GENH 750 W in 1U 1/2 19” rack
1 2 3 8 4 7 6 5
1 ON/OFF Switch
2 Air Intake allows zero stacking for maximum system
flexibility and power density.
3 Reliable encoder controls Output Voltage and sets
Address, OVP, UVL Limits.
4 Volt Display shows Output Voltage and directly displays
OVP, UVL and Address settings.
5 Reliable encoder controls Output Current, sets Baud
rate and Advanced Parallel Mode.
6 Current Display shows Output Current and displays
Baud rate. Displays total current in Parallel Master/
Slave Mode.
7 Function/Status LEDs:
l Alarm l Fine Control l Preview Settings
l Fold-back Mode l Remote Mode l Output On
8 Push-buttons allow flexible user configuration:
• Coarse and Fine adjustment of Output Voltage/
Current and Advanced Parallel Master/Slave Mode.
• Preview settings and set Voltage/Current with Output
OFF, Front Panel Lock.
• Parallel Master/Slave
• Set OVP and UVL Limits
• Set Current Fold-back
• Local/Remote Mode and select Address and
Baud rate.
• Output ON/OFF and Auto-Re-Start/Safe-Start Mode.
Rear panel description GENH 750 W in 1U 1/2 19” rack
1 6 2 3 9 4 5 8 7
1 Remote/Local Output Voltage Sense Connections.
2 DIP Switches select 0–5 V or 0–10 V Programming and
other functions.
3 DB25 (Female) connector allows (Non-isolated) Analog
Program and Monitor and other functions.
4 RS-485 OUT to other Genesys Power Supplies.
7 Exit air assures reliable operation when zero stacked.
8 Input:
• IEC 320 connector for 750 W models (85 – 265 V AC)
9 Optional Interface Position for IEEE 488.2 SCPI or
Isolated Analog Interface or LAN interface (shown).
5 RS-232/RS-485 IN Remote Serial Programming.
6 Output Connections:
• 750 W (shown) units: Rugged busbars up to 60 V
Output. Wire clamp terminal for output 80 to 600 V
models.
29