Download - TDK-Lambda

Recovery time / deviation
Load current switches from positive to negative (750 W)
GEN12.5-60 PSINK
Vout = 40 V, Iout = +8 A → –1 A
Deviation
[V]
Percentage [%]
Recovery to 0.5 % or 100 mV whichever is greater
[ms]
Vout = 60 V, Iout = +5 A → –1 A
Deviation
[V]
Percentage [%]
Recovery to 0.5 % or 100 mV whichever is greater
[ms]
Programming down speed
12.5 → 0 V
Fall time (90 % – 10 %) (1*) [ms] < 3
Note 1: In case of Analog programming Fall time slew rate is 200 µs/1 V.
Note 2: Values are typical at 25 °C
NEW
Specifications Genesys GEN 1500 W Power Sink (Option)
Specifications Power Sink (1500 W)
GEN12.5-120 PSINK
Sink power rating
Max. peak power (thermal limited) Tamb = 25 °C [W] 200
Max. peak power (thermal limited) Tamb = 50 °C [W] 100
Max. sink peak power duration [s] 30
Recovery time for max. peak power [s] 900
Max. continues power, Tamb = 25 °C [W] 55
Max. continues power, Tamb = 50 °C [W] 35
Power derate above 25 °C [%/ °C] 1.5
Duty cycle for use at peak power
PSINK = 80 W, Tamb = 25 °C [s] ton ≤ 10 s, toff ≥ 10 s
PSINK = 80 W, Tamb = 25 °C [s] ton ≤ 20 s, toff ≥ 21 s
PSINK = 80 W, Tamb = 25 °C [s] ton ≤ 30 s, toff ≥ 36 s
PSINK = 120 W, Tamb = 25 °C [s] ton ≤ 10 s, toff ≥ 22 s
PSINK = 120 W, Tamb = 25 °C [s] ton ≤ 20 s, toff ≥ 50 s
PSINK = 120 W, Tamb = 25 °C [s] ton ≤ 30 s, toff ≥ 90 s
PSINK = 160 W, Tamb = 25 °C [s] ton ≤ 10 s, toff ≥ 40 s
PSINK = 160 W, Tamb = 25 °C [s] ton ≤ 20 s, toff ≥ 90 s
PSINK = 160 W, Tamb = 25 °C [s] ton ≤ 30 s, toff ≥ 170 s
Power derate above 25 °C [%/ °C] 2
Protection
Electronic power limit, over current
Max. sink current [A] 65
Sink over voltage protection typical trip point
(In case of higher sink current than the maximum current)
[V] 15.5 – 19.5
Thermal overload protection
In case of power sink thermal
Recovery time / deviation
Load current switches from positive to negative
GEN12.5-120 PSINK
Vout = 6 V, Iout = +40 A → – 15 A
Deviation [V] 0.5
Percentage [%] 8.33
Recovery to 0.5 % or 100 mV whichever is greater [ms] 5.5
42