HP LaserJet P2015 Printer Software Technical Reference - ENWW

More documents

Recommendations

Info

◦ Rough paper. This setting increases transfer current. The texture in the surface of rough papers, such as cotton bond papers, carries a large portion of the surface area away from contact with the OPC drum. In this case, more transfer current is required. ◦ Less/More transfer (-2, -1, +1, +2). These settings provide two levels of decreased transfer bias voltage and two levels of increased transfer bias voltage if the other adjustments are insufficient. Increment this control to find the best setting. In extreme case (very dry or very wet), low transfer current defects and high transfer current defects can overlap; that is, a defect-free setting might be impossible. These adjustments can help find the best operating point. ● Duplex Transfer. Paper that has passed through the fuser before being printed on the second side is much drier and has higher resistivity than when the first side is printed. Therefore, the engine uses different transfer bias settings for the second side. It is common for the second side to show a transfer defect while the first side does not. These adjustments allow second-side defects to be improved without affecting transfer performance on the first side (or vice versa). The following settings are available for the Duplex Transfer control. ◦ Dry paper. This setting increases transfer bias. Some papers (notably Chinese papers) become highly resistive in dry environments. To improve transfer, increase the transfer bias voltage. The range of paper resistivity in low humidity is so wide that a single, standard engine print mode cannot cover all the cases. ◦ Humid paper. This setting decreases transfer bias. All papers absorb water at higher humidities and become electrically less resistive, resulting in transfer defects. The engine has a humidity sensor and also checks the conductivity of the ETB in order to estimate the humidity of the media, but this can be inadequate in more extreme cases. ◦ Rough paper. This setting increases transfer current. The texture on the surface of rough papers, such as cotton bond papers, carries a large portion of the surface area away from contact with the OPC drum. In this case, more transfer current is required. ◦ Less/More transfer (-2, -1, +1, +2) . These settings provide two levels of decreased transfer bias voltage and two levels of increased transfer bias voltage if the other adjustments are insufficient. Increment this control to find the best setting. In extreme case (very dry or very wet), low transfer current defects and high transfer current defects can overlap; that is, a defect-free setting might be impossible. These adjustments can help find the best operating point. ● Toner. This adjustment is applied by the formatter. The following settings are available for the Toner control. ◦ Less toner (-1, -2, -3) . These settings decrease the maximum primary toner amount from 100% to 95%, 90%, and 85%, respectively. This is useful for fixing toner scatter on highresisitivity papers in low humidity environments. ● Discharge. The following settings are available for the Discharge control. ◦ On/Off. The HP LaserJet P2015 printer has an electrostatic discharge brush where the paper separates from the ETB (before the fuser). This prevents toner scatter after a sudden paper discharge. Because the brush can sometimes make scatter worse, this setting is provided to turn the discharge brush off. 48 Chapter 2 Software description ENWW
Optimize section System Setup The Optimize settings are applied to all media printed depending on the engine’s internal tables. The following controls are available: ● Background Toner. The On setting selects optimized EP process parameters for reducing background on glossy paper. ● Extra Cleaning. High acid content or “talc” papers tend to leave a conductive residue on the OPC drums. The On setting turns on increased OPC/ETB cleaning rotations before and after pages are printed to help rub off this residue. ● Trailing Edge Over-development (full-speed). The On setting selects optimized EP process parameters for decreasing trailing edge over-development in full speed (Light and Plain media types). Trailing edge over-development is a jump-gap developer defect which causes excess toner at trailing edges of halftoned or solid areas. ● Trailing Edge Over-development (half-speed). The On setting selects optimized EP process parameters for decreasing trailing edge over-development in half speed (heavy and glossy media types). Trailing edge over-development is a jump-gap developer defect which causes excess toner at trailing edges of halftoned or solid areas. ● Mottle Prevention. The On setting selects optimized EP process parameters for decreasing developer mottle. This problem has largely been eliminated by cartridge and toner design changes. Use the System Setup screen to change the system defaults for the HP LaserJet P2015 printer. Figure 2-25 System Setup screen ENWW HP ToolboxFX 49 Software description
Page 1:
HP LaserJet P2015 Printer Software
Page 4 and 5:
Copyright and license ©2007 Copyri
Page 6 and 7:
Status folder .....................
Page 8 and 9:
Print-driver user interface .......
Page 10 and 11:
JPEG Passthrough (PS 3 Emulation Un
Page 12 and 13:
x ENWW
Page 14 and 15:
xii ENWW
Page 16 and 17: Figure 2-40 HP EWS - Print Info Pag
Page 18 and 19: Figure 5-6 License dialog .........
Page 20 and 21: Table 1-1 Software technical refere
Page 22 and 23: Printing-system software The HP Las
Page 24 and 25: Click the Support & Drivers link. O
Page 26 and 27: Table 1-4 Software component availa
Page 28 and 29: Table 1-5 CD part numbers for the H
Page 30 and 31: ● EL = Greek ● EN = English ●
Page 32 and 33: HP LaserJet documentation The docum
Page 34 and 35: Table 1-8 User documentation availa
Page 36 and 37: MS Windows printing-system software
Page 38 and 39: The following drivers are available
Page 40 and 41: HP ToolboxFX This section provides
Page 42 and 43: HP Device pop-up alert messages Pop
Page 44 and 45: Device Status The Device Status scr
Page 46 and 47: Device Configuration The Device Con
Page 48 and 49: Print Info Pages Use the Print Info
Page 50 and 51: Set up Status Alerts Use the Set up
Page 52 and 53: Set up E-mail Alerts Use the Set up
Page 54 and 55: Troubleshooting ● Animated Demons
Page 56 and 57: Animated Demonstrations Figure 2-15
Page 58 and 59: Device Information Use the Device I
Page 60 and 61: Printing PCL5e Use the Printing scr
Page 62 and 63: Print Quality Use the Print Quality
Page 64 and 65: Table 2-2 Standard print modes (con
Page 68 and 69: Service The following Jam recovery
Page 70 and 71: IP Configuration The IP Configurati
Page 72 and 73: SNMP Table 2-3 Advanced Network Set
Page 74 and 75: Network Configuration Password The
Page 76 and 77: About HP ToolboxFX dialog box Click
Page 78 and 79: ● USB drivers are unsigned ● En
Page 80 and 81: Obtaining debugging information fro
Page 82 and 83: 5. Add the disabling option by typi
Page 84 and 85: Device Status The Device Status pag
Page 86 and 87: Network Configuration page Print In
Page 88 and 89: Device Information page The Device
Page 90 and 91: PostScript page Use the PostScript
Page 92 and 93: System Setup page Service page Use
Page 94 and 95: Advanced page Bonjour page Use the
Page 96 and 97: Network Configuration page The Netw
Page 98 and 99: HP Web Jetadmin Use the HP Web Jeta
Page 100 and 101: Installation overview The software
Page 102 and 103: 3. Follow the onscreen prompts to i
Page 104 and 105: 3. Insert the HP LaserJet P2015 pri
Page 106 and 107: 8. Click Next to accept the updated
Page 108 and 109: Plug-and-play installation for a di
Page 110 and 111: 8. Click Finish to continue copying
Page 112 and 113: Microsoft Windows installation for
Page 114 and 115: 5. Type the path and share name of
Page 116 and 117:
Click Begin Setup to initiate a ser
Page 118 and 119:
In any dialog box where it is avail
Page 120 and 121:
Figure 3-17 USB install - Do Not Bl
Page 122 and 123:
Figure 3-20 USB Install - sample Sy
Page 124 and 125:
Figure 3-22 USB install - HP Extend
Page 126 and 127:
Figure 3-24 USB install - Ready to
Page 128 and 129:
Select the Directly to this compute
Page 130 and 131:
Figure 3-29 USB install - Restart y
Page 132 and 133:
Figure 3-31 USB install - Test Page
Page 134 and 135:
Figure 3-33 HP Registration screen
Page 136 and 137:
Figure 3-35 Network install - Sampl
Page 138 and 139:
Figure 3-37 Network install - Insta
Page 140 and 141:
Figure 3-39 Network install - Licen
Page 142 and 143:
Figure 3-41 Network install - Desti
Page 144 and 145:
Figure 3-43 Network install - Conne
Page 146 and 147:
Figure 3-45 Network install - Searc
Page 148 and 149:
Figure 3-47 Network install - Print
Page 150 and 151:
Figure 3-49 Network install - Confi
Page 152 and 153:
Figure 3-51 Network install - Resta
Page 154 and 155:
Click OK if the test page prints su
Page 156 and 157:
138 Chapter 3 Install MS Windows pr
Page 158 and 159:
● Services tab features ● Devic
Page 160 and 161:
Properties driver tabs This set of
Page 162 and 163:
Whenever a constraint message appea
Page 164 and 165:
The requested number of copies appe
Page 166 and 167:
Printer Features The Printer Featur
Page 168 and 169:
The Paper/Quality tab contains the
Page 170 and 171:
Table 4-1 Print Task Quick Set defa
Page 172 and 173:
Paper Options Size is The settings
Page 174 and 175:
Paper size Units The name that appe
Page 176 and 177:
● HP LaserJet Paper ● HP Premiu
Page 178 and 179:
First Page NOTE: Use the same size
Page 180 and 181:
Last Page NOTE: Use the same size o
Page 182 and 183:
The Source is: setting specifies th
Page 184 and 185:
Effects tab features To gain access
Page 186 and 187:
Figure 4-12 Preview images - Legal
Page 188 and 189:
Click Edit, and the Watermark Detai
Page 190 and 191:
◦ Medium ◦ Medium Dark ◦ Dark
Page 192 and 193:
The Finishing tab contains the foll
Page 194 and 195:
Select the media type that correspo
Page 196 and 197:
Booklet layout Table 4-4 Page orien
Page 198 and 199:
Page Order The Page Order drop-down
Page 200 and 201:
Services tab features To gain acces
Page 202 and 203:
Device Settings tab features The De
Page 204 and 205:
The trays listed in the Form to Tra
Page 206 and 207:
7. Click the External Fonts option.
Page 208 and 209:
Convert Gray Text to PostScript Gra
Page 210 and 211:
The HP LaserJet P2015 supports the
Page 212 and 213:
About tab features The About tab is
Page 214 and 215:
196 Chapter 4 HP PCL 6, PCL 5, and
Page 216 and 217:
Macintosh printing-system software
Page 218 and 219:
CD versions The HP Macintosh printi
Page 220 and 221:
Macintosh install and uninstall ins
Page 222 and 223:
4. The main Installer dialog appear
Page 224 and 225:
Figure 5-5 HP LaserJet for Macintos
Page 226 and 227:
Click Install to start the installa
Page 228 and 229:
2. In the Applications folder, open
Page 230 and 231:
If you want to use the IP Printing
Page 232 and 233:
Set up a printer with Mac OS X V10.
Page 234 and 235:
c. On the first configuration page,
Page 236 and 237:
If you are using IP Printing, carry
Page 238 and 239:
● Networking tab Access to the HP
Page 240 and 241:
Supplies Status page The Supplies S
Page 242 and 243:
Network Configuration page The Netw
Page 244 and 245:
● System Setup page ● Service p
Page 246 and 247:
PCL5e page Use the PCL5e page to ch
Page 248 and 249:
System Setup page Service page Use
Page 250 and 251:
Advanced page Bonjour page Use the
Page 252 and 253:
Network Configuration page The Netw
Page 254 and 255:
236 Chapter 5 Macintosh ENWW
Page 256 and 257:
Troubleshooting This section contai
Page 258 and 259:
FixErr1714 utility This utility is
Page 260 and 261:
Uninstall instructions for Microsof
Page 262 and 263:
5. When the uninstall process is co
Page 264 and 265:
Table 6-2 Supported media attribute
Page 266 and 267:
Table 6-5 Specifications for automa
Page 268 and 269:
Microsoft Windows printer drivers T
Page 270 and 271:
NOTE: To install additional printer
Page 272 and 273:
WARRANTY AND COPYRIGHT © 2006 Copy
Page 274 and 275:
Connection Type screen (Windows net
Page 276 and 277:
Settings 69, 225 SNMP page 77, 233
Page 278 and 279:
page orientation settings unidriver
Page 280 and 281:
Service screen, HP ToolboxFX 50 Ser
Page 282:
264 Index ENWW
show all

HP LaserJet P2015 Printer Software Technical Reference - ENWW

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?