COMSOL Multiphysics™

TABLE 2-2: GEOMETRY MODELING ERROR MESSAGES
ERROR NUMBER ERROR MESSAGE EXPLANATION
2146 Subdomain must bounded at least four Incorrect geometry for mapped mesh.
boundary segments
2147 Subdomain must bound one connected edge Incorrect geometry for mapped mesh.
component only
2190 Invalid radius or distance Incorrect input parameters to fillet/chamfer.
2197 Operation resulted in empty geometry
object
2209 Geometry to revolve may not cross axis of
revolution
Geometry operation resulted in an empty
geometry object which is not allowed. Make
sure an empty geometry object is not
created.
The axis of revolution and the geometry
intersect. Check the dimension of the
geometry and the definition of the axis for
the revolution.
4000–4999 Mesh Generation
TABLE 2-3: MESH GENERATION ERROR MESSAGES
ERROR NUMBER ERROR MESSAGE EXPLANATION
4002 A degenerated tetrahedron was created The mesh generator ran into numerical
difficulties while creating tetrahedrons with
a size based on user-controlled parameters.
Causes could be too small and narrow
subdomains relative to the rest of the
geometry or exceedingly short boundary
segments. Try to avoid creating small and
narrow subdomains and very short
boundary segments that are adjacent to
longer boundary segments.
4003 A degenerated triangle was created The mesh generator ran into numerical
difficulties while creating triangles with a
size based on user-controlled parameters.
Causes could be too small and narrow
subdomains relative to the rest of the
geometry or exceedingly short boundary
segments. Try to avoid creating small and
narrow subdomains and very short
boundary segments that are adjacent to
longer boundary segments.
ERROR MESSAGES | 411