6388 Wireless Router User's Guide - Zhone Technologies

3. Using the Web Interface
Procedure
1. From the Home screen, click on Setup.
2. Under LAN Setup, select LAN Configuration. The LAN Group 1 Configuration
screen appears, as shown in Figure 3-15, LAN Group 1 Configuration.
3. Click on “Use the following Static IP Address”.
4. Enter a new IP Address and Netmask.
The Apply button will temporarily save these settings. To make the change
permanent, click on Tools (at the top of the page) and select System Commands.
At the System Commands page, click on Save All.
Ethernet Switch
To set the speed and duplex mode of the LAN ports:
Procedure
1. From the Home screen, click on Ethernet Switch. The Ethernet Switch screen
appears.
2. For Physical Port1 through Physical Port4 (LAN1 through LAN4), select a
mode and speed from the Set Value drop-down list. Select Auto to negotiate
the Ethernet duplex mode and speed with attached equipment that supports
auto-negotiation.
The current configured or negotiated settings are displayed under Fallback Value.
The Apply button will temporarily save the Ethernet Switch settings. To make the
change permanent, click on Tools (at the top of the page) and select System
Commands. At the System Commands page, click on Save All.
Figure 3-16.
Ethernet Switch
6388-A2-GB20-00 February 2005 3-21