Owner's Manual - Universal Remote Control
Owner's Manual - Universal Remote Control
Owner's Manual - Universal Remote Control
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Auto-Search Method<br />
The Auto-Search Method is a way you can<br />
scan through all of the codes in the table to<br />
find the right code for your component.<br />
STEP 1: <strong>Manual</strong>ly or using your old remote,<br />
turn on the component you want to program—for<br />
example, to program your TV,<br />
turn on your TV set.<br />
STEP 2: On the WR7, press the Component<br />
button that you want to program (in this<br />
case the button that says TV) and the<br />
SELECT [SEL] button at the same time. Hold<br />
down both buttons for two seconds until the<br />
TV Component button light turns on. This signals<br />
that you are in programming mode.<br />
IMPORTANT: You have 30 seconds to perform<br />
the next step while you are in programming<br />
mode. If you do not press a button<br />
within 30 seconds, the component LED light<br />
will turn off. The remote will exit the programming<br />
mode and you will have to start<br />
over.<br />
UP�<br />
ARROW<br />
DOWN�<br />
ARROW<br />
Page 14
Change language