Owner's Manual - Universal Remote Control

Transport Control “Punch Through”
This “punch through” enables you to program
the WR7 so that VCR or DVD Transport Controls
(PLAY, STOP, FF, REW, PAUSE, SKIP and RECORD)
will also operate in other component modes on the
remote control.
STEP 1: Press and hold the component button
you want to add Transport Control to, such
as [CABLE/SAT] or [TV], and the SELECT [SEL]
button at the same time for two seconds until
the Component LED light turns on.
IMPORTANT: You have 30 seconds to perform
the next step while you are in programming
mode. If you do not press a button within
30 seconds, the component LED light will turn
off. The remote will exit the programming mode
and you will have to start over.
STEP 2: Press the [PLAY] button. The component
LED light will blink once.
STEP 3: Press either the [DVD] or [VCR]
button that you want to use as the source of
Transport Control. The component LED will
blink three times to confirm it is saved.
Page 28
COMPONENT
BUTTONS
SELECT
PLAY