Owner's Manual - Universal Remote Control
Owner's Manual - Universal Remote Control
Owner's Manual - Universal Remote Control
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Erasing Commands -<br />
Overview<br />
You can erase a single learned command, all<br />
learned commands in each component mode,<br />
SimpleSound programming, MacroPower commands,<br />
or re--set the remote to original factory<br />
default settings.<br />
Erasing a Single Learned Command from<br />
One Component<br />
STEP 1: Press the component button where<br />
the learned command is stored and the [ENTER]<br />
button at the same time for two seconds until the<br />
component LED light turns on.<br />
IMPORTANT: You have 30 seconds to perform<br />
the next step while you are in programming<br />
mode. If you do not press a button within 30 seconds,<br />
the component LED light will turn off. The<br />
remote will exit the programming mode and you<br />
will have to start over.<br />
STEP 2: Press and hold the button you<br />
want to erase for two seconds. The component<br />
LED light will blink twice to confirm the<br />
erasure.<br />
STEP 3: Repeat Step 2 to erase any other<br />
buttons in the selected component mode.<br />
STEP 4: To exit Erase mode, press and<br />
hold both the component button and the<br />
[ENTER] button at the same time until the<br />
component LED light blinks three times.<br />
Page 30<br />
COMPONENT<br />
BUTTONS<br />
ENTER
Change language