Owner's Manual - Universal Remote Control
Owner's Manual - Universal Remote Control
Owner's Manual - Universal Remote Control
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Programming WR7 using<br />
the Learning Method<br />
STEP 1: Line up the WR7 to the remote control<br />
you want to “learn” from, head--to--head as shown<br />
below. Start with both remotes’ IR windows touching<br />
(or nearly touching).<br />
STEP 2: On the WR7, press the Component<br />
button that you want to program (in this case<br />
the button that says TV) and the ENTER [ENT]<br />
button at the same time. Hold down both buttons<br />
for two seconds until the TV Component<br />
button light turns on. This signals that you are<br />
in programming mode.<br />
IMPORTANT: You have 30 seconds to perform<br />
the next step while you are in programming<br />
mode. If you do not press a button within<br />
30 seconds, the component LED light will<br />
turn off. The remote will exit the programming<br />
mode and you will have to start over.<br />
STEP 3: Press any button on the WR7 that<br />
you want to teach a command to. For example,<br />
if you want to teach the [MUTE] button on the<br />
WR7 the TV Mute command from the other<br />
remote, first press the [MUTE] button on the<br />
WR7 and the TV component button LED light<br />
will blink once indicating that the WR7 is ready<br />
to learn the command.<br />
Page 16